WolfPack KWNG01 Manual De Instrucciones página 23

PARTS LIST
OPERATION
Prepare for operation switch-on switch-off
Make sure the stapler has no visible damage before starting work. Check that the battery is
charged. Load the staples or nails specified by the manufacturer into the feeder, and suitable for
the work you will be doing.
To operate the stapler it must be switched on with the main switch on the back of the handle fig.
A4 to position I. Only after this is it possible to operate the trigger Fig. A2. To switch off the
stapler the main switch fig. A4 must be set to position 0.
Magazine loading
With this cordless stapler, you can use 4-10 mm long staples or 10 mm long nails.
• Squeeze the staple feeder catch fig A6 on the back of the tool towards the centre of the
magazine and pull out the staple feeder.
NOTE: Once the staple or nail strip is placed in the feeder, it will be pressed down by the
spring. Hold the catch firmly to prevent the feeder from suddenly ejecting from the tool.
• Coloque la tira de grapas como se muestra en la Fig. C1.
• Place the nail strip as shown in fig. C2 on the side of the magazine that is marked with the
corresponding symbol fig. C3
• Push the staple feeder forward until you hear a distinct click, the staple feeder is then secured.
• Figure A8 shows an inspection hole to check the number of staples, nails in the feeder.
1. Battery charge indicator
2. Trigger
3. Handle grip
4. Main switch
5. USB charging port
6. Staple/nail magazine socket
7. Contact switch
8. Magazine status inspection hole
23