Publicidad
Idiomas disponibles
Idiomas disponibles
Scraper Z52 A1
Materials
mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application
–
removal of material residues, such as tile
adhesive, when replacing damaged tiles
Changing tools
NOTE
►
If you plan to use the dust collection unit, it
must be connected before fitting or changing
the tool (see section "Connecting a dust
extraction device").
WARNING! RISK OF INJURY!
■
Always remove the plug from the power
socket before working on the power tool.
■
Check that the tool is fitted firmly. Incorrectly or
insecurely fitted tools can come loose during
use and cause you an injury.
■
If necessary, remove an already fitted tool.
To do this, raise the tool release lever
■
8
│
GB │ IE
■
Fit the tool (e.g. the plunge saw blade
the tool holder.
NOTE
►
You can fit the tools in any snap position on
the tool holder.
■
Lock the tool into place by pushing the tool
release lever
Fitting the sanding sheet onto
the sanding plate
Attaching
♦
Sanding sheets
pad
fastening.
NOTE
►
Before fitting a new sanding sheet
any dust and dirt from the sanding pad
►
Note that the holes for dust extraction from
sanding sheet
aligned.
♦
Position the sanding sheet
of the sanding pad
sheet on the sanding plate.
Operation
Switching on and off
Switching on
♦
Push the ON/OFF switch
the appliance on.
.
Switching off
♦
Push the ON/OFF switch
switch the appliance off.
back down again.
are attached to the sanding
by means of the hook and pile
and sanding pad
flush on one side
, then place the sanding
forwards to switch
backwards to
PMFW 310 F4
) onto
, remove
.
are
Publicidad
