Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions for engine
swap:
• If the engine is not in the correct position for the
installation, connect the plug and press the button 6
on the hand switch. The motor will move into position
for installation.
• For security reasons again pull the plug from the
socket. For an easy installation, place the bed frame
upside down so the steel pipes face upwards. Now
fi rmly press the engine through the nail-shaped
projections until the tubes remain in the "u" form gap.
• Make sure the symbol for the back on the engine
shows to the head of the bed frame. At the T5 Black
the holes in the top of the engine are closed on the
tubes with sliding covers, which fi t into the center
of the slot.
• After completing the installation, place the slatted
frame on the bed frame and connect the plug, so the
internal energy storage can recharge itself.
• Then place the battery.
Emergency lowering:
So you can leave the slatted frame in a reclining po-
sition at power failure, the bed has special equipment
connected to an integrated of 9-V alkaline battery,
which is automatically activated when pressing the
button 6. If the hand switch fails, the "coding" button
can be pressed on the engine. The download speed
is reduced. Although the battery can hold several
emergency descents, we recommend changing after
each descent, or after a maximum of three years, due
to the deterioration of the same.
TWINMOT
Hand switch (functions):
1 – Back part up
2 – Back part down
1
3 – Foot part up
3
4 – Foot part down
5
5 – Foot and back part up
6 – Foot and back part down
Synchronization:
• Hand switch with the motor: Keep pressing the
button 2 and 3 at the same time and then press the
"coding" button at the motor. A sound will be heard
confi rming synchronization.
• Hand switch with two engines: Keep pressing the
button 2 and 3 at the same time and then press
the "coding" button located in each
of the two motors. A sound will be
heard in both engines confi rming
synchronization.
Technical data:
Connecting power supply
100-240 Volt AC 50-60 Hz.
The engine works with a DC voltage of 24 V DC.
Maximum conncetion time: 10% with continuous
operation is 2/18 minutes.
Operating voltage for the hand switch is 24 V DC.
Power required, depending on load and models:
30-300 W.
T5
Black
- 7-
2
4
6
Publicidad
