Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING THE RADIO
Your radio is equipped with memory capacity in order to store the time and your selected
preset channels. When the radio is in the OFF position, this memory capacity is powered
by one coin cell battery that is included with the radio.
TO INSTALL COIN CELL BATTERY
WARNING: Danger of explosion if battery is incorrectly replaced. When replacing
battery, replace it with the same or equivalent type CR2032. Observe correct polarity
(+ and –) when replacing batteries. Do not store or carry batteries so that metal objects
can contact exposed battery terminals.
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect radio from power source before installing/changing battery.
1. Remove the screw from the coin cell battery door (14). Remove the door from the radio.
2. Install the coin cell battery so that the writing on the battery faces out away from the radio.
3. Replace the battery door and tighten screw.
NOTE: To reset the LCD display (9), clock and pre-sets, remove the coin cell battery and
reinstall. Follow this procedure if the screen seems to lock in place.
POWER/VOLUME ADJUSTMENT
1. To operate as a corded product, insert the AC adapter (15) into the AC adapter port
(11), then plug the adapter into an appropriate AC power outlet or generator.
2. To operate as a cordless product, insert a fully charged 20v Max* Porter Cable
battery (not included) into the battery port (12). Be sure battery is fully seated.
3. To turn the radio on, press the power button (2). Press the power button again to turn
the radio off.
4. Press the top volume button (1) to increase the volume. To decrease the volume, press
the bottom volume button.
NOTE: If the battery is attached to the radio and the AC adapter is plugged in at the same
time, the radio will run off of the adapter and not drain the battery. Having both attached
simultaneously will not charge the battery.
MODE FUNCTION
To choose one of the mode functions (FM, AM, AUX, or Bluetooth
button (3) until the desired function is displayed on the LCD screen. For example, if the
radio is on FM, push the mode button two times to change to AUX.
TUNE OR SEEK FUNCTION
To Tune:
Press the top tune / seek button (8) to quickly move the tuner up the frequency band. To
move the tuner down the frequency band, press the bottom tune / seek button.
To Seek:
Press and hold the top tune / seek button (8), then release to quickly scan up the
frequency band to the next available station. Press and continue to hold the button to seek
directly to a desired station. Press and hold the bottom tune / seek button (8), the release
to quickly seek down the frequency band.
TO PROGRAM THE CLOCK
The clock can be programmed with the power on or off.
1. Press and hold the equalizer / clock button (6) until the hour numbers of the digital time
flashe on the LCD display (9), then release the equalizer / clock button.
2. Press the tune/ scan buttons (8) up or down to set the hour.
3. When the correct hour is set, press the equalizer / clock button once so the minute
numbers flash.
4. Press the tune/ scan buttons up or down to set the minutes.
5. If you do not press a button within 5 seconds, the clock programming feature will
automatically return to the previous setting. The clock is set once the numbers stop flashing.
5
®
) push the mode
Publicidad
