ETI EVPLUS7C Manual De Instalación Y Funcionamiento página 39

8.1.3 WiFi CLIENT mode
When in CLIENT mode, the charger can be connected to an available WiFi network. The charger
control can be achieved by a server which supports the OCPP protocol.
The current series of ETI`s chargers supports the OCPP 1.6 J version of the protocol.
To configure the WiFi interface of the charger in CLIENT mode the user should perform the
following steps.
Important note: before switching to CLIENT mode all the needed configurations must
be completed in AP mode.
Step Description
No.
1 Open the black front panel, just sliding the two locks in
the charger backside
2 Press the button highlighted in the following picture for
more than 3 sec. continuously
3 Wait for the sound (1 sec. duration) from the charge,
which says the change of WiFi mode has been
completed
4 The WiFi indicator will change its colour from blue to
green
5 Close the black front panel of the charger.
February 2023
Picture
37