Kinderkraft Lumi 2 Manual De Uso página 24

Product description
no.
1
3
5
Product assembly/disassembly:
Follow the fig. A and M.
The installation should take place on a soft ground that will not damage the surface of the
elements. All parts of the rocker (1, 2, 3, 4, 5, 6) should be carefully inspected after taking it out
of the box and make sure that none of them are damaged. Unfold the seat. Then connect the
frame components using the pins on both sides (fig. A). The clicking of the pins characterises
correct assembly. Then, slide the cover material over the seat frame and fasten the hook and
loop fasteners (fig. B). The picture (fig. C) shows a correctly assembled frame with cover
material. Next, slide the legs of the bouncer (3) onto the footrest with the control panel (2) and
fasten the four screws (6) with a cross-head screwdriver (which is not included in the product)
(fig. D). Thus assembled place the foot of the rocker on the ground. With both hands, grasp the
seat (fig. E) and gently push the seat pin into the hole in the foot. When the elements connect,
you will hear a characteristic sound (click). Attention! Adjust the shape so that the seat can
connect to the foot without obstacles or force. Slide the toy bar (4) onto the seat frame (fig. F).
To dismantle the product, press the metal button at the back of the foot of the rocker (Figure
G) and then, with firm move, separate the seat from the foot of the rocker. To disassemble the
frame of the bouncer, slide the cover material off the frame of the bouncer (fig. H), then press
the pins and separate the frame parts with a firm movement (fig. I). Slide the cover material
from the frame. The rocker has a rocking function. If you want the seat to swing to the sides,
move the locking button upwards (Figure L). Attention! Do not activate the rocker function if
the button is in the motion blocking position. The rocker has two belt heights. Choose one of
these depending on the size of your child.
Cushion adjustment
Adjustment is by means of a Velcro strap (Figure M). By sliding the belt buckle down, you can
adjust the cushion lower, while by pulling the belt buckle up, you can adjust the cushion higher.
Velcro straps on the adjusting belt and cushion are used to stabilize the position of the cushion.
Installation/replacement of batteries in the rocker:
To install or replace the batteries, use a Phillips screwdriver (not included), unscrew the safety
Item description
Seat
Legs
USB-DC cable
no.
2
4
6
23
Item description
Rocker foot
Toy bar
Screws x4