Linea 2000 DOMO DO1056DV Manual De Instrucciones página 41

Idiomas disponibles

Screw the uppermost screws into place and put the cover plates back.

Examine the door alignment and the seal again before you screw the lowermost hinge into place. If

necessary, adjust the adjustable feet so that they align in one direction.

MOVING YOUR APPLIANCE

If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will

allow the refrigeration system pressures to equalise before restarting.

Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile

parts (shelves, accessories, etc.) or fix them into the freezer to avoid any shock.

Relocate and install. If the appliance has been left on its side for any length of time, leave it standing

upright for at least 10 minutes.

Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly

and natural gas, it is explosive. Therefore you should be careful during shipment and installation

to prevent your appliance's cooler elements from being damaged. In the event of a leak caused by

damage to the cooler elements, move your fridge from open flame or heat sources and ventilate the

room where the appliance is located for a few minutes.

USE

CONTROL PANEL

LED display: temperature and mode indicator

Sup: super freezing (SF) indicator light

Eco: energy saving (SE) indicator light

Mode: adjusting the mode

Locking/unlocking indicator light

Setting: adjusting the temperature

TURNING ON AND OFF

To turn on the appliance, press the Setting button for 5 seconds. Do the same to turn off the appliance.

www.domo-elektro.be

DO1056DV