Kukirin G2 Master Guia De Inicio Rapido página 5

EN
8.Operation instruction
Display device
Brake handle
Handle grip
Headlight switch
Turn signal
Loudspeaker
Left turn
Non-zero start
Single drive
NON
Double drive
SINGLE
Voltage
Battery level
Headlight mark
1.Long press the power button to turn it on/off.
2.Short press the power button once to switch gears. There are three levels.
3.Short press the single and dual drive buttons once to switch between single and dual drive modes.
4.Press the power button three times in a row to enter the menu setting interface. The instrument panel will display
P01, P02, P03, P04, P05, P06, P08, PA, PB.
P01: Kilometer/mile selection settings, (default is kilometers).
P02: Voltage level setting, 36V/48V/52V/60V/72V (default value is 52V).
P03: The unit of wheel diameter is inch, which can be set to 080-160 (default is 100).
P04: Speed measurement magnetic pole range: 1-100, (default is 30).
P05: Cruise selection, 0 is no cruise, 1 is cruise, (default is no cruise).
P06: Zero start/non zero start settings, 0 is zero start, 1 is non zero start, (default is zero start).
P08: For the setting of sleep time, 0 is not sleep, and other numbers are sleep time, (default is 5 minutes).
PA: Starting force setting, 1-5, 1 minimum, 5 maximum.
PB: For the braking force setting, it is from 0-5, 0 is turned off, and the braking force of 1-5 gradually increases.
05
Single/Dual-drive conversion
Throttle thumb shifter
On/Off
Speed
Right turn
Brake mark
Speed limit indicator box
Gear
Speed unit
Mileage/Fault code
Cruise signs
9.Troubleshooting
Malfunction
Code
Retry after replacing the rear motor/controller.
Rear motor malfunction E001
Throttle malfunction E002 Retry after replacing the throttle.
Controller malfunction E003 Retry after replacing the controller.
Under-voltage E005 Low battery level, recharge and retry.
Instrument malfunction E006 Retry after replacing the instrument/controller.
Retry after replacing the instrument/controller.
Instrument malfunction E007
Over-temperature protection
Check if the controller fixing/cooling is good.
E009
Front motor malfunction E0011 Retry after replacing the front motor/controller.
Controller malfunction E0013 Retry after replacing the controller.
Controller malfunction E0017 Retry after replacing the instrument/controller.
10.Charging
Friendly reminder: When charging, the charger indicator light is red; it turns green when fully charged.
Charging port
11.Warranty
From the date of receipt to the warranty period, if this product occurs malfunctions or is damaged,it can be
repaired, exchanged, or returned for free after being tested and confirmed by the KuKirin after-sales center.
When applying, please contact the product seller and follow the instructions. At that time, you need to
provide accurate, complete, and valid purchase information or invoices.
Warranty content
Controller, instrument, motor, lithium battery, charger.
Frame, front body, rear wheel hub, brakes,folding,body lever, front
fork, brake system, throttle dial,etc.
EN
Solutions
Charging port
Warranty period
Half a year
1 year
06