Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART
5
Drain the fuel tank Clean the fuel line. Replace the fuel filter.
PROBLEM:
The engine will not start.
1.
Follow the stops, "How To Start The Engine" in this book
2.
Electdc_Start Models: Clean the battery terminals. Tighten the
cables.
3.
Drain the fuel tank. Clean the fuel line. Replace the fuel filter.
4.
Remove the spark plug(s). Move the throttle to the SLOW posF
tlon. Turn the ignition key to the ON position Try to start the em
gine several times. Install the spark plug.
5.
Replace the spark plug
6.
Adjust the carburetor.
PROBLEM:
The engine will not turn over.
1.
Follow the stops "How To Start The Engine" in this book
2.
Electdc_Start Models: Check the level of the acid in the battery.
If needed add water. Charge the battery.
3.
Replace the fuse.
4.
Check the wiring harness for damage or a loose connection.
Repair the damaged wire.
5.
Electdc_Start Models: replace the solenoid. RecoiFStart Mod_
els: replace the module.
PROBLEM:
The engine
is difficult
to start.
1.
Adjust the carburetor.
2.
Replace the spark plug
3.
Replace the fuel filter.
PROBLEM: The engine does not run smooth or has a
loss of power.
1.
Check the oil.
2.
Clean the air filter.
3.
Clean the air screen.
4.
Replace the spark plug.
5.
The engine is working too hard. Use a lower gear.
6.
Adjust the carburetor.
7.
Replace the fuel filter.
PROBLEM: The engine
does not run smooth at fast
speed.
1.
Replace the spark plug
2.
Adjust the throttle control
3.
Clean the air filter.
4.
Replace the fuel filter.
PROBLEM:
The
engine
stops when the blades are
engaged.
1.
Check the wiring harness for damage or a loose connection.
Repair the damaged wire.
PROBLEM: On slopes, the engine stops.
1.
MOW up and down slopes Never mow across a slope.
PROBLEM:
The engine will not idle.
1.
Replace the spark plug.
2.
Clean the air filter.
3.
Adjust the carburetor.
4.
Adjust the throttle control
PROBLEM:
A hot engine
causes
a decrease
in power.
1.
Clean the air screen.
2
Check the oil.
3
Adjust the carburetor,
4
Replace the fuel filter,
PROBLEM:
Excessive
vibration.
1.
Replace the blade.
2
Check for loose engine bolts.
3
Decrease the air pressure in the tires.
4
Adjust the carburetor,
5
Check for a damaged belt or damaged pulley
Replace the
damaged parts.
PROBLEM: The grass does not discharge correctly.
1.
Stop the engine. Clean the mower housing.
2.
Raise the height of cut.
3.
Replace or sharpen the blade(s).
4
Move the shift lever to a slower speed.
5
Move the throttle control to the FAST position.
6
Replace the spring for the blade idler,
PROBLEM:
The mower
housing
does not cut level.
1.
Check the air pressure in the tires.
2
Adjust the level of the mower housing
3
Check the front axle. If the front axle does not freely pivot Ioes_
en the axle bolt(s)
PROBLEM: The mower blades will not rotate.
1.
Check the mower drive belt. Make sure the belt is installed coF
rectly,
2
Replace the mower drive belt.
PROBLEM:
The
unit will not move
when
the clutch
is
engaged.
1
Check the motion drive belt Make sure the belt is installed
correctly.
2.
Adjust the clutch.
3.
Replace the motion drive belt.
PROBLEM: The unit moves slower or stops when the
clutch is engaged.
1
Adjust the clutch.
2.
Replace the motion drive belt.
PROBLEM:
When the clutch/brake
pedal is released,
belt
noise can be heard.
1
Temporary belt noise does not change the operation of the unit
If belt noise is continuous
check the routing of the belt. Make
sure the belt is inside all belt guides.
2.
If the noise is continuous, adjust the clutch.
PROBLEM:
The rear wheels
spin over uneven
terrain.
1
Check f_e front axle. If the front axle does not freely pivot Ioes_
en the axle bolt(s}
F-0406010
34
Publicidad
