Hammerbacher VXBHM Serie Instrucciones De Montaje página 15

Operation memory switch
Adjusting the Table Top height
Risk of minor or moderate injury through crushing.
Your fi ngers may be crushed when you attempt to change the
height of the table.
• Keep fi ngers away from moving parts.
• Ensure that no persons or objects are in the table's
range of motion.
The Table Top will move up or down until the UP or DOWN Key is released, or if a pre-defi ned
stopping point has been reached.
To move the Table Top UP
▸ Press and hold the UP Key until the desired height has been reached.
To move the Table Top DOWN:
▸ Press and hold the DOWN Key until the desired height has been reached.
Saving a memory position
This function saves a set Table Top position. One Memory Position can be saved
per Memory Position Key.
1. Move the table to the desired height using the arrow keys.
▸ The display shows the Table Top height (e.g. 73 cm).
SAVE
2. Press the SAVE Key.
2
3. Press the Memory Position Key (e.g. "2").
▸ The display shows "S 2"
▸ After about two seconds, the Table Top height is displayed again.
Adjusting the table to a Memory Position
2
1. Press and hold the required Memory Position Key (e.g. "2").
▸ The Table Top will move until the saved Table Top height has been reached.
If you release the Key before the Memory Position is reached,
the table will stop.
2
2. Release the Memory Position Key.
▸ The display shows the Table Top height (e.g. 73 cm).
(VXBHM2C)
English
Container-Stop and Shelf-Stop-Positions
These features can limit the movement area of the Table Top (if e.g. a container is below the table or a shelf
is above it).
You must set each position separately.
• Container Stop Positions can only be saved in the
• Shelf Stop Positions can only be saved in
SAVE
SAVE
CORRECTING THE HEIGHT DISPLAY
This feature changes the height displayed on the Hand Control.
It does not aff ect the table's actual height.
SAVE
0 73
SAVE
lower half of the movement area.
the upper half of the movement area.
To save a Shelf Stop / Container Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the
desired position.
2. Press and hold the SAVE Key for 10 seconds.
▸ The Control Box will click 2x.
- Container Stop is activated when you are in the lower half of the movement
area,
- Shelf-Stop when you are in the upper half.
To delete a Shelf Stop (upper position) / Container Stop (lower position):
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a Shelf
Stop Position) or bottom half (Container Stop Position) of the movement area.
2. Press and hold the SAVE Key for 10 seconds.
▸ The Control Box will click 1x.
▸ The Container Stop / Shelf Stop Position is deleted.
1. Press the SAVE Key.
▸ The display shows "S –".
2. Press and hold the DOWN Key for approximately 5 seconds.
▸ The display starts to fl ash.
3. Use the UP Key or DOWN Key to set the new height.
4. Press the SAVE Key.
▸ The height display is now set to the new Table Top height.
English
(VXBHM2C)