Kompernaß nevadent NZR 1.5 A1 Instrucciones De Uso página 51

Power supply
♦ Use a 1 .5 V battery 6 to operate the appliance .
To insert the supplied battery 6 proceed as follows:
3) Push the housing 7 back onto the hand set 4 until it sits
firmly in place and the gap is fully closed . The anti-slip
dimples on the housing 7 must be on the same side as
the anti-slip dimples on the hand set 4 . The writing on
the housing 7 must be on the same side as the operat-
ing button 5 .
NOTE
► If the effectiveness of the cleaning starts to decrease, the
battery 6 needs to be replaced .
Handling and use
This section provides important information about proper hand-
ling and operation of the appliance .
Fitting the cleaning attachment
1) Remove the appliance head 1 by turning it slightly so
that the dot on the appliance head 1 is aligned with the
head 1 upwards and off .
2) Push the attachment fitting 3 into the hole of one of the
cleaning attachments 2 in the storage box 8 . You will
feel a slight click .
3) Pull the hand set 4 away from the storage box 8 . The
cleaning attachment 2 comes out of the storage box 8 .
4) Check that the cleaning attachment 2 is firmly attached
to the attachment fitting 3 . If necessary, push the cleaning
attachment 2 onto the attachment fitting 3 with slightly
more force .
NZR 1.5 A1
1) Carefully pull the housing 7 off the hand set 4
and place it to one side .
2) Insert the battery 6 . Pay attention to the polarity
markings given in the battery compartment .
symbol on the hand set 4 . Then pull the appliance
GB │ MT │ 49 ■