Publicidad
Idiomas disponibles
Idiomas disponibles
-the thermostat is at the correct setting.
4. When the refrigerator operates too noisily:
-the refrigerator is not touching furniture that can transmit or amplify a noise or a
vibration.
-the refrigerator properly levelled.
-the containers or solid packages stored inside are not touching each other.
-the mains supply is stable.
If you refrigerator is still not functioning properly after making the above checks, please
contact the sale dealer immediately.
Note: During the period of high humidity, moisture may form on the outside of the
refrigerator, it is not unusual. You may just wipe it up yourself.
11. REPLACING THE LAMP
1. Turn the thermostat to the off position "0" and disconnect from the mains.
2. Remove all the food from the top shelf of the fridge and pull it forwards slightly.
3. The lamp is in the back of the thermostat housing, remove the plastic lens by
pressing the front center of the lens whilst pulling upwards on the small lip on the bottom
of the lens at the front.
4. Unscrew the lamp in a clockwise direction and screw a new lamp into the lamp holder
in an anti-clockwise direction until finger tight.
5. Replace the lens by locating the rear lug and pressing home firmly.
6. Set the thermostat to your preferred setting and close the door.
7. If the power cable is mangled to avoiding danger should require replacement, this
must only be undertaken by technical service branch or a suitably qualified person, as
special purpose tools are required
8.The lamps maximum rating is 10W, 220-240V
Lamp-holder: E14
12. OLD APPLIANCES
The cabinet of appliance is formed by cyclopentane. Old appliance contains harmful
16
Publicidad
