Descargar Imprimir esta página

MyBinding HSM shredstar S10 Instrucciones De Servicio página 8

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
1 Proper use, warranty
The shredder is to be used exclusively for
shredding small quantities of paper. Please
make sure that the paper does not contain any
paperclips . Paperclips can damage the cutting
device .
The warranty period for the document shredder
is 2 years. this warranty excludes wear, dam-
age due to improper handling, natural deprecia-
tion, and actions taken by third parties.
2 Safety instructions
• read all instructions before start-up of the
paper shredder . Save these instructions for
later use .
• Follow all warnings and instructions marked
on the product!
Risk of injury!
Do not reach into the paper feed
slot .
Risk of injury by pulling in!
keep long hair, loose articles of
clothing, ties, scarves, jewelery
etc . away from feed opening .
Material with the tendency to form
loops, e.g. tapes, strapping material,
etc . must not be shred .
Risk of combustion!
Do not use cleaning agents or
pressurized air sprays which con-
tain inflammable substances, as
they could ignite .
Keep paper shredder out of the
reach of children . This shredder
should be operated only with an
operator in attendance .
5/2012
Shredstar_S10_manual_2012_37.indd 7
shredstar
Switch the shredder off if it is dam-
aged or not working correctly or
before relocating or cleaning it and
disconnect it from the power plug .
Service work may only be carried
out by HSM Customer Service or
by the service technicians of our
contractual partners .
• make sure no liquid is spilled on or in the paper
shredder .
• make sure the power plug is easily accessible.
• Before plugging in the plug, check that the
voltage and frequency of your local supply
correspond to those stated on the type plate .
• the shredder is for indoor use only and
must not be placed near a heater or other
heat source . The ventilation slots must not
be blocked or covered and they must be at
a distance of at least 4" (10 cm) away from
walls or furniture .
3 Machine components
2 3
4
1
1
Cut material container
2
feed opening
3
Slider switch
4
Cutting head
®
7
7/5/2012 1:20:29 PM

Publicidad

loading