Classe CA-3200 Manual De Instrucciones página 18

Idiomas disponibles

Important:

conﬁguring balanced/

single-ended operation

Initial Setup

Your new Classé ampliﬁer is quite simple to set up and enjoy. Please follow the

steps outlined below in order to safely set up and use your new ampliﬁer.

The AC mains connection should be the last connection you

make on your new power ampliﬁer. In addition, it is always

a good idea to power up your power ampliﬁer(s) last, after

everything else has been powered up and has stabilized.

Conversely, it is good practice to power the ampliﬁer(s) down

ﬁrst when shutting down the system, as this prevents any

transients from other components from getting through to

your loudspeakers.

Unpack everything according to the included instructions.

Be careful when doing so, as this ampliﬁer is quite heavy.

Place your ampliﬁer (be sure to read "Unpacking and Placement")

and connect it to the AC mains.

This includes deciding on the location, making sure you have adequate

ventilation, and adequate clearance for all the wires behind the ampliﬁer.

Once accomplished, connect the ampliﬁer directly to the AC mains. Do

not use extension cords, as most are not suitable for the current sometimes

required by your ampliﬁer.

Conﬁgure your ampliﬁer.

The Select and Mode buttons are used when conﬁguring your ampliﬁer

for how you would like it to operate.

While in standby, pressing the Select button will cause some of the Chan-

nel LEDs to light up, indicating how the ampliﬁer is currently conﬁgured

(either balanced or single-ended) for each channel.

One of the Channel LED indicators will be blinking, indicating that you

may select either balanced or single-ended operation for that particular

channel. Press the Mode button to toggle between either the balanced

mode or the single-ended mode of operation, indicated by one of the two

Channel LEDs remaining on.

Press the Select button again to select the next channel, and repeat the pro-

cess until the ampliﬁer is conﬁgured as you desire. To ﬁnish, continue to

press and release the Select button until all the Channel LEDs are off.

Make sure you conﬁgure the ampliﬁer to use the type of input connection

you will be using for each channel. You may safely use any combination of

single-ended and balanced input connections your system requires.