Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
IMPORTANT: Ensure that all guards and shrouds are in place before
pressing reset switch to restart the motor. If the motor shuts down
because of overload, wait 10-15 minutes for the motor to cool down,
and then press the reset switch to restart motor. The reset switch button
is located on the motor housing.
The pressure switch acts as a pilot device activating the motor. The
pressure switch cut in/cut out has been preset at the factory, do not
tamper with the settings.
result from improper pressure setting. Consult your local distributor or
service center if the switch malfunctions. The pressure switch controls the
on/off operation of the air compressor, it can be turned off manually but
when it is in the auto position, it allows the air compressor to start or shut
down automatically without warning depending upon air tank charge
condition.
NOTE: Always set this switch to off when the compressor is not in use
The air pressure regulator enables you to adjust outlet pressure to the
tool in use.
pressure, or turn counterclockwise to decrease pressure to the tool. Turn
the thread nut against knob to lock in place.
6
Never bypass or remove this switch, as serious
damage to equipment or personal injury could
and before unplugging compressor.
Never exceed maximum working pressure of the
tool. To adjust, turn clockwise to increase
Publicidad
