Publicidad
Safety warnings
When using a cordless angle grinder
Specific safety measures for
Abrasive cutting operations
a) Do not jam the cutting wheel or apply excessive pressure. Do not
attempt excessive depth of cut. Overloading the wheel increases the
load and susceptibility to twisting or jamming in the cut, also raising
the risk of kickback or disc breakage.
b) Do not position your body in line and behind the disc. When the
disc, at the point of operation, moves away from your body,
potential kickback can propel the disc and the power tool directly
toward you.
c) When the disc is jammed or when interrupting a cut for any
reason, turn off the power tool and keep it stationary until the disc
comes to a complete stop. Never attempt to remove the cut-off
wheel while it is in motion, as kickback can occur. Investigate and
take corrective measures to eliminate the cause of the wheel jam.
d) Do not restart the cutting operation on the workpiece. Allow the
disc to reach its full speed and carefully re-enter the cut. The disc
may jam, lift, or kick back if the power tool is restarted on the
workpiece.
e) Support panels or any large workpiece to minimize the risk of
wheel jamming and kickback. Large workpieces tend to sag under
their own weight. Supports should be placed beneath the workpiece
near the cut line and close to the edge of the workpiece on both
sides of the disc.
f) Exercise extra caution when performing a "plunge cut" in existing
walls or other blind areas. The protruding wheel can cut gas or
water pipes, electrical cables, or objects that may cause kickback.
Incorrect way to operate
the angle grinder
• Performing operations for which this power tool is not designed
can lead to an accident and cause personal injuries.
• It is not recommended to use this power tool for operations such
as sanding, planing, or polishing.
• Do not use accessories that are not specifically designed and
recommended by the manufacturer.
Incorrect way to operate the angle grinder
Correct way to operate
the angle grinder
• The outer diameter and thickness of accessories must be within
the assigned capacity.
• Incorrectly sized accessories cannot be adequately protected or
controlled. For best results, use a 4 1/2" cutting and/or grinding
disc with a thickness of 1 mm - 6.4 mm.
• Operate the angle grinder at an angle of 15° to 30° for the best
results.
Correct way to operate the angle grinder
15° a 30°
ENGLISH
7
Publicidad
