Publicidad
Idiomas disponibles
Idiomas disponibles
• Never use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during
storage.
Add
stabilizer
to gasoline
in fuel tank or
storage
container.
Always
follow
the mix
ratio found
on stabilizer
container.
Run
engine
at least 10 minutes
after adding
stabilizer
to allow the stabilizer
to reach
the carburetor.
Do not drain the gas tank
and carburetor
if using fuel stabilizer.
ENGINE
OIL
Drain oil (with engine
warm)
and replace
with clean engine
oil. (See "ENGINE"
in
the Maintenance
section
of this manual).
CYLINDER
1. Remove spark plug.
2. Pour one ounce (29 ml) of oil through
spark plug hole into cylinder.
3. Pull starter handle slowly a few times
to distribute oil.
4. Replace with new spark plug.
OTHER
• Do not store gasoline
from one season
to another.
• Replace
your gasoline
can if your can
starts to rust. Rust and/or
dirt in your
gasoline
will cause
problems.
• If possible,
store your unit indoors
and
cover it to protect
it from dust and dirt.
• Cover your unit with a suitable
protec-
tive cover that does not retain moisture.
Do not use plastic.
Plastic
cannot
breathe,
which allows
condensation
to
form and will cause your unit to rust.
IMPORTANT:
Never cover mower while
engine
and exhaust
areas are still warm.
_, CAUTION:
Never store the lawn mower
with gasoline
in the tank inside
a building
where
fumes
may reach an open flame or
spark.
Allow the engine
to cool before
storing
in any enclosure.
TROUBLESHOOTING
- See appropriate
section
in manual
unless directed
to a Sears Service Center,
PROBLEM
CAUSE
CORRECTION
Does not start
1. Dirty air filter.
1. Clean/replace
air filter.
2. Out of fuel.
3. Stale fuel.
4.
Water in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Loose blade or broken
blade adapter.
8. Control bar in released
position.
9. Control bar defective.
10. Fuel valve lever (if so
equipped) in OFF position.
11.Weak battery (if equipped).
12.Disconnected
battery
connector (if equipped).
2.
Fill fuel tank.
3.
Drain tank and refill with
fresh, clean fuel.
4.
Drain fuel tank and
carburetor
and refill tank
with fresh gasoline.
5.
Connect
wire to plug.
6.
Replace
spark
plug.
7. Tighten
blade bolt or
replace
blade adapter.
8.
Depress
control
bar to
handle.
9.
Replace
control
bar.
10.Turn
fuel valve lever
to the ON position.
11 .Charge
battery.
12. Connect
battery
to engine.
16
Publicidad
