Publicidad
Idiomas disponibles
Idiomas disponibles
When selectively sanding on the spot, the sanding sheet can heat up considerably. Reduce
the orbital stroke rate and allow the sanding sheet to cool down regularly.
A sanding sheet that has been used for metal should not be used for other materials.
9.6.4
Scraping
For scraping, select a high oscillation rate.
Work on a soft surface (e.g. wood) at a flat angle and apply only light pressure. Otherwise the
scraper can cut into the surface.
10 CLEANING AND MAINTENANCE
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Make sure no water can reach the inside of the power tool!
11 TECHNICAL DETAILS
Model nr.
Voltage
Number of speed settings
No load speed
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
Copyright © 2021 VARO
POWDP4060
POWDP4060
20 V
6
5000-20000 /min-1
82 dB(A)
93 dB(A)
8,7 m/s²
P a g e
| 10
EN
K = 1,5 m/s²
www.varo.com
Publicidad
