UFESA TW Osaka Manual De Instrucciones página 15

INSTALLATION
After removing the packing, check the condition of the appliance. If in doubt, do not
use it and take it to a professional, qualified technician. The packaging (plastic bags,
polystyrene, fixtures, etc.) should be kept out of the reach of children. They are a po-
tential source of danger and they should be disposed of in the appropriate specific
containers for selective waste collection.
Warning: any stickers or leaflets attached to the grille must be removed before using
the appliance. Before connecting the appliance, check that the voltage values indicated
on the characteristics plate correspond to those of the electric mains supply. In the
event that the mains socket and the appliance plug are incompatible, have the plug
changed to one that is suitable by a professional, qualified technician.
Make sure that the cable part of the power cord is adapted to the power used by the
appliance. In general, the use of adapters or extension cables are not advisable. If this
is necessary, they must be in accordance with the safety regulations and their ampera-
ge capacity must not be less than the maximum capacity of the appliance.
Before each usage, check that the appliance is in good condition and the power cord is
not damaged. If in doubt, check with a professional, qualified technician.
The mains socket must be easily accessible in order to disconnect the appliance with
ease in case of emergency.
Position the appliance away from:
- sources of heat (e.g. open flames, gas ovens, etc.)
- deposits of liquids (e.g. sinks, etc.) to avoid falling into or splashing with water (mini-
mum distance 2 meters).
- fabrics (curtains, etc.) or loose materials, which may obstruct the ventilation grille.
Additionally, make sure that the front part is free from volatile materials (dust, etc.).
The supporting surface must be stable, flat and even (so that the appliance does not
tip over).
FUNCTIONS & OPERATION
After unpacking, check whether the body is in good condition and whether there is any
defect.
Plug in first
Insert the plug into the socket, product will be in standby mode.
Standby button
Push "STANDBY" button to turn on the appliance and it will start in Speed 1 (F1 will
appear on the digital display). Push it again to switch the appliance in standby mode.
SPEED button
Push "SPEED" button to change the speed between LOW (F1), MIDDLE (F2) and HIGH
(F3).
SWING button
Push "SWING" button to activate the swing function, push it again to stop the function.
Note: Do not turn the body directly by hand and change the air supply direction forci-
bly, otherwise the swing function will get damaged.
15