Kenmore 36367667790 Manual Del Propietário página 14

Reversing Door Swing
(continued)
Transferring the top hinge
Reinstall the top hinge (and shim glued to it) on the left
front corner of the cabinet but do not tighten the screws
at this time_
Some hinges have four holes Which holes you use for
installing the hinge depends on which side you insta_i
the hinge,.
The outer edge of the hinge should be parallel to the
edge of the case for correct installation.
installing the hinge
on the left
Transferring door handles
(on models so equipped)
Fresh food door
To remove the handle...
(a) Remove the handle
plug using a tape-tipped
putty knife under the
edge, and remove the
screw underneath,
(b) Remove lwo screws
holding the handle to the
top of the door_
(c) Remove the handle
| t
Installing the hinge
on the right
After removing the handle...
(a) Remove the screws Plug
from the right edge of the Button
door top and insert them
onto the handle screw
holes on fi!e opposite side..
(b) With tape-tipped putty Handle Holes
knife or' thin-blade
screwdriver, pry out the Plug
plug button from the hinge Button
hole on the left side of the
door' and insert it into the
hole on the opposite side
that was vacated by
removal of the top hinge
(c) Purl the plug button from the front of the door and
transfer it to the opposite side,
(d) Transfer the door stop
LEFT SIDE Door Stop
° Move the metal door stop from the right side to the left
side Use a Torxdriver,
• Move any screws from the left side to the right side,
When reinstalling the fresh food door handle...
° Attach the handle to the right side of the door with
screws at the top and under the handle plug,
. Reinstall the handle plug.
Freezer door
(a) Remove the screw
holding the handle to the
top of the door and the
lwo screws holding the
handle to the bottom of
the door.
(b) Remove the hand_e,
(c) Remove the screw
from the right top edge
of the door and insert it
into the handle screw
hole on the left side_
(d) Transfer the door
stop as shown above.
(e) Attach the handle to
the right edge of the door with screws at top and
bottom, using bottom holes vacated by removal
of the door stop screws.
I4