Kärcher SGV 8/5 Classic Manual Del Usuario página 16

Replacing the coarse dirt filter
1. Open the cover of the wastewater
container.
2. Press the lock of the wastewater
container upwards.
3. Remove the wastewater container.
4. Unlock the wastewater container
lock and remove the cover.
5. Turn the cover 180° and set it down.
6. Pull the coarse dirt filter off the filter
holder and replace it.
Maintenance intervals
Annually
1. Have the device descaled by Cus-
tomer Service.
Troubleshooting guide
DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
DANGER
Danger from hot water, steam and
hot surfaces
Risk of scalding and burns
Allow the device to cool down prior to
all work on the device.
DANGER
Danger from improper repair work
Risk of injury and damage
ave repair work carried out by the au-
thorised customer service only.
"Service" indicator light flashes yel-
low
Error: E07
1. Switch off the device, wait briefly,
switch the device on again.
2. If the indicator light does not go out,
repeat the procedure (max. 4 times).
16
Error: E14
Pre-warning for descaling (still 100h)
1. Have the device descaled by Cus-
tomer Service.
"Service" indicator light lights up
yellow
Descaling
1. Have the device descaled by Cus-
tomer Service.
"Fresh water reservoir empty" indi-
cator light lights up red
1. Refill with fresh water.
2. Correctly insert the fresh water res-
ervoir, push it in as far as it will go.
"Wastewater container full" indica-
tor light lights up red
1. Drain the waste water.
2. Fit and lock the wastewater contain-
er correctly.
"Malfunction" indicator light flashes
red
1. Switch off the device.
2. Check the fresh water tank for a cor-
rect fit.
3. Switch the device on again.
4. If the indicator light does not go out,
repeat the procedure (max. 4 times).
The "Service" indicator lamp lights
up yellow and the "Malfunction" in-
dicator lamp lights up red at the
same time.
1. Contact Customer Service.
"Malfunction" indicator light lights
up red
Error: E12
1. Check the accessory plug for a cor-
rect fit.
2. Switch off the device, wait briefly,
switch the device on again.
3. If the error occurs repeatedly, notify
Customer Service.
English