Publicidad
Idiomas disponibles
Idiomas disponibles
5. Pull the starter rope handle slowly until you feel
resistance.
6. Release the starter rope handle to let the starter
rope go back.
7. Pull the starter rope handle until the engine starts.
8. Open the choke control gradually until it is fully open.
9. Let the engine operate at idle speed for 2–3 minutes.
10. Set the throttle control to full throttle.
To stop the product (Honda)
1. Set the throttle control to idle speed.
2. Let the engine operate at idle speed for 2–3 minutes.
10
3. Set the engine ON/OFF switch to OFF. The engine
stops.
4. Move the fuel valve to the OFF position.
Compaction indicator (optional)
A
B
•
A: Yellow LED. The degree of compaction is 0–30%.
•
B: Yellow LED. The degree of compaction is 30–
60%.
•
C: Green LED. The degree of compaction is 60–
90%.
•
C and D: Green and red LED. When these
LED indicators flash, the ground surface has the
maximum degree of compaction that is applicable for
the product.
•
D: Red LED. The degree of compaction is 90–100%.
CAUTION:
product when the LED indicator (D) is
on with a constant red light. This causes
wear to the product.
•
E: Red or green. Power supply indicator.
When you turn the ignition key, a calibration of the
compaction indicator starts. All LED indicators (A) to
(E) come on. After approximately 4 seconds, the LED
indicator (E) changes from red to green and the LED
indicators (A) to (D) go off. When the LED indicators (A)
to (D) are off and the LED indicator (E) is green, you can
start the product.
To operate the product
Always operate the product with the throttle control set
to full throttle.
•
To operate the product forward, move the operation
control fully forward and release it.
C
D
E
Do not operate the
2425 - 001 - 12.04.2024
Publicidad
