Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
SAFETY WARNING - BUTTON CELL BATTERIES
This product contains button cell batteries. KEEP OUT OF REACH OF CHILDREN.
Ingestion may result in chemical burns, soft tissue perforation and death. Severe burns may occur
within 2 hours of ingestion. Seek immediate medical attention.
Do not give to food or drink, and do not induce vomiting. If you have the battery packaging, present
it to the doctors when you take over. Do not use if battery compartment is damaged or does not
close. Do not allow children to replace batteries without adult supervision. Remove used batteries
immediately and dispose of them in an appropriate recycling facility.
USAGE
Always select the correct battery size and type for the intended use. Follow the instructions on the
device. Always insert batteries correctly, paying polarities (+ and -) marked on the battery and the
equipment. Replace all batteries in a set at the same time. Do not short-circuit batteries. Do not
charge batteries. Do not force discharge. Store batteries in a well-ventilated, dry place at a moderate
temperature.
PRODUCT INSTALLATION
POWER SUPPLY
Please use the attached power, note that power voltage and frequency are the same as the marked voltage and
frequency of device when connecting power. Every device's power should be connected separately, so that de-
vice can be controlled individually.
CABLE SPEC.
CABLE (EU)
CABLE (US)
Brown
Black
Light Blue
White
Yellow/Green
Yellow/Green
DMX CONNECTION
Connection between lights and DMX must use the shied cable of diameter more than 0.5mm. Please use the
attached 3 pin XL plug/socket to connect the DMX output/input interface. The connection between socket and
cable as below (note the plug/socket's 3 pin number and position).
DMX-OUTPUT
XLR mounting-sockets (rear view)
2
When using standard DMX512 control signal, the last device's output interface must be connected to a DMX plug.
This plug is putting a 120 ohm resistance between "canon" plug's 2 pin and 3 pin. Showing as below pic. Sticking
this plug into the last device's signal output interface, it will avoid the interference during the process of signal
transmission.
PIN
Live
Neutral
Earth
1 ∙ Shield
2 ∙ Shield (-)
1
3 ∙ Shield (+)
3
INTERNATIONAL
L
N
DMX-INTPUT
XLR mounting-plugs (rear view)
2
1
3
P.16
LEN
FUSE : 250V~ 1A
PIN3
PIN2
Publicidad
