fatboy CHAP-O Manual página 6

Battery:
If the battery will not hold a charge any-
more, please contact your Fatboy® dealer.
The disposal of electronic devices con-
taining battery's should be in compliance
with any local regulations that address
the disposal of hazardous materials. Do
not incinerate!
Instructions for use:
- When using outdoors basic safety
precautions should always be followed
to reduce the risk of fire, electric shock,
and personal injury, including
the following.
- Make sure to position the Chap-O in a
suitable location:
• When using this product outdoors,
we recommend you avoid exposing it
to any direct rain or water from other
sources, such as sprinklers, to keep
water from entering the lamp.
• Hanging/Mounting instructions:
Using the wallmount and cord provided
with Chap-O. When using the wall-
mount included please note following:
The mounting screw/plug (included)
can be used at stone, concrete or
brick walls.
• Please make sure to use the correct
fasteners in case you would like to ap-
ply Chap-O to another kind of surface.
• The wallmount should be able to
support a minimum of 5kg to comply
with basic safety regulations. If needed,
ask a professional for advice.
• Make sure the lamp is fixed well
wherever you use it, so it won't fall. This
could cause injury or damage!
- Make sure to connect the USB
connector correctly to avoid damage.
6 - EN
- Do not expose the lamp to excessive
heat from heat sources.
- Always charge the lamp indoors.
Connect the USB/Magnet charging cable
to the USB adapter. Plug the recommend-
ed 5V 1A adapter into the wall socket.
Snap the magnetic pogopin to the back
of the lamp to start charging. The lamp
can easily be taken out of the shade
because it is connected by a magnet.
- For first time use, we advise you to
charge the built-in battery for at
least 2 hours.
- For normal charging, it will take approx.
1.5 hours to fully charge the lamp.
- The lamp can be operated by pressing
the button on the front side
of the lamp.
1: The lamp is turned off
2: Press one time: the light will turn on.
3: Press and hold to set the light
intensity. The brightness will increase
and decrease in a loop and will remain
at the chosen intensity once the
switch is released.
4: Press third time: the light
will turn off.
5: Press again: the lamp will turn on
again to the last intensity setting.
6: Pressing the button twice (while on)
will allow you to directly set the lamp
to 100% or 10% brightness.
- When the lamp stops emitting light, it
needs to be recharged. Always charge
the lamp indoors.