Publicidad
Idiomas disponibles
Idiomas disponibles
Domus 4/English
4. Operation
General operation
4.1.
Switch on the main power switch found on the side of the pump.
(1)
Once the pump begins delivering air into the mattress, it will take approximately
(2)
30 minutes to fully inflate the mattress.
Every time when mattress is first setup for use, It will be forced to execute
(3)
Maxfirm for the quickest inflation. The low-pressure indicator (yellow LED) will
light up when the mattress is not fully inflated at initial inflation. If the appropriate
pressure is reached, the low-pressure indicator (yellow LED) will go off.
When the initial inflation (Maxfirm process) is completed, the system will enter
(4)
the "alternating mode".
According to the weight and height of the patient, adjust the pressure setting to
(5)
the most comfortable level without bottoming out, then the pressure in mattress
will slowly increase to the intended value after the air mattress is ready to use.
NOTE: Every time when mattress is first setup for use, it will be
forced to execute Maxfirm for the quickest inflation. User can then
adjust air mattress to the desired softness afterward.
Emergency CPR Operations
4.2.
NOTE:
emergency to perform CPR on
the patient, quickly turn the CPR
knob
mattress. The CPR knob is
located at the head-end, right-
hand-side of the mattress. The
quick connector on the pump
unit can be disconnected for
even faster deflation.
NOTE: After CPR, re-activate auto adjustment to ensure proper
pressure setting. Please make sure the CPR valve and quick
connector are correctly connected, and always performs hand-
check after Auto-Adjust or Tuning process.
When
there
to
release
air
is
an
from
9
Publicidad
