Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INFORMATION
- TRIM-
MER HEAD
TRIMMER
HEAD
NOTE:
If your unit has been assembled
for weed blade use, refer to the section
ASSEMBLY
INFORMATION
FOR USING
YOUR UNIT WITH A WEED BLADE and re-
verse
the steps
to remove
the metal
shield
and blade before you mount the
plastic shield and trimmer head.
ATTACHING THE PLASTIC SHIELD
AND TRIMMER HEAD
A
EL WARNING:
The shield must be
properly installed. The shield provides
partial protection from the risk of thrown
objects.to the operator and others and is
equipped with a line limiter which cuts
excess line to the proper length. The line
limiter (on underside of shield) is sharp
and can cut you.
• Remove wing nut from shield.
• Insert bracket into slot on shield.
• Pivot shield until bolt passes through
hole in bracket.
• Tighten the wing nut securely.
• If your unit has a plastic cover over the
threads on the threaded shaft, remove
the covering to expose the threads.
• Before installing the trimmer head,
make sure the dust cup and retaining
washer are positioned on the gearbox
as shown below.
Bracket _.
Slot "_..."_/_ing
Nut
Shield
Dust Cup //J_
RetainingWasher J(?_j
NOTE: Make sure all parts are properly
installed as illustrated in the illustration
before installing the trimmer head.
• Align hole in the dust cup with the hole
in the side of the gearbox by rotating
the dust cup.
• Insert a small screwdriver into aligned
holes. This will keep the shaft from
turning while tightening trimmer head.
Screwdriver
• While holding the screwdriver in posi-
tion, thread
trimmer head onto the
shaft in the direction shown on the de-
cal. Tighten until secure.
NOTE: The retaining washer must be
positioned with the raised section facing
toward the gearbox.
ASSEMBLY INFORMATION
-
WEED BLADE
WEED
BLADE
NOTE:
If your unit has been assembled
for trimmer
head use, refer to the section
ATTACHING
THE PLASTIC SHIELD AND
TRIMMER HEAD and reverse the steps to
remove
the plastic
shield and trimmer
head before you mount the metal shield
and blade. Store these parts for future
use. Never use the trimmer head with the
metal blade installed.
ASSEMBLY
OF THE METAL SHIELD
DANGER:
The metal shield must
be properly installed on the tool anytime
the tool is used with the blade. The for-
ward tip of the metal shield helps to re-
duce the occurrence of blade thrust
which can cause serious injury such as
amputation to the operator or bystand-
ers. Failure to install the shield in the
position shown can result in serious inju-
ry to the operator. The length of the
shield must be aligned with the length of
the tube. The blade is sharp and can cut
6
Publicidad
