Hilti SF 6-A22 Manual De Instrucciones página 8

These numbers refer to the corresponding illustrations found at the
beginning of these operating instructions
The numbering reflects the sequence of operations shown in the
illustrations and may deviate from the steps described in the text
Item reference numbers are used in the overview illustrations and
refer to the numbers used in the product overview section
This symbol is intended to draw special attention to certain points
when handling the product.
1.3 Product-dependent symbols
1.3.1 Symbols on the product
The following symbols can be used on the product:
Wireless data transfer
Hilti Li-ion battery type series used. Observe the information given in
the section headed Intended use.
Li-ion battery
Direct current (DC)
Drilling without hammer action
Drilling with hammer action (hammer drilling)
Protection class II (double-insulated)
Rated speed under no load
Revolutions per minute
1.4 Product information
products are designed for professional users and only trained,
authorized personnel are permitted to operate, service and maintain the
products. This personnel must be specifically informed about the possible
hazards. The product and its ancillary equipment can present hazards if
used incorrectly by untrained personnel or if used not in accordance with
the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Drill/driver
Generation
Serial no.
2 English
Printed: 19.08.2019 | Doc-Nr: PUB / 5467429 / 000 / 01
SF 6-A22 | SF 6H-A22
02
2231427
*2231427*