EGO PRO X HTX5300-P Manual Del Usuario página 11

TROUBLESHOOTING
PROBLEM CAUSE
◾
The battery pack is not attached to
the hedge trimmer.
◾
No electrical contact between the
hedge trimmer and battery pack.
◾
The battery pack charge is
depleted.
◾
The battery pack is too hot. See
the chapter "Battery High-
temperature Protection".
◾
Hedge trimmer
The hedge trimmer is too hot. See
doesn't work.
the chapter "Machine High-
temperature Protection".
◾
The front and rear triggers are not
depressed simultaneously.
◾
The blade is jammed.
◾
The battery pack has electronics
error. See the chapter "Battery
Electronics Error Protection".
◾
Dry or corroded blades.
◾
Blade or blade support is bent.
Excessive
vibration or
◾
Bent or damaged teeth.
noise.
◾
Loose blade bolts.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
56 VOLT LITHIUM-ION ACCUHEGGENSCHAAR —— HTX5300-P
SOLUTION
◾
Attach the battery pack to the hedge trimmer.
◾
Remove the battery pack, check contacts and
reinstall the battery pack
◾
Charge the battery pack.
◾
Remove the battery pack and cool the battery pack
until the temperature drops below 67°C.
◾
Remove the battery pack and cool the hedge
trimmer until the temperature drops below 80°C.
◾
Press and hold the front trigger first, move the lock-
off lever forward, and then press the rear trigger.
◾
Remove the battery pack from the machine,
remove the obstruction carefully, then reinsert the
battery pack and restart the machine.
◾
Replace the battery pack or contact EGO customer
service center.
◾
Lubricate the blades, following the instructions in
the "LUBRICATING THE BLADES" section in this
manual.
◾
Replace with a new blade or support. Contact EGO
service center for blade or support replacement.
◾
Replace with a new blade. Contact EGO service
center for blade replacement.
◾
Tighten the blade bolts. Use an adjustable wrench
and the included hex key to tighten the blade bolts
clockwise.
EN
11