Ariens A149K21 Manual Del Propietário página 13

• 1=
WARNING: To avoid serious iniury, Mowing
before performing any service and A po, sition
adjustments:
1. Release control bar and stop engine.
2. Make sure the blade and all moving
parts have completely stopped.
3. Disconnect spark plug wire from spark
plug and place wire where it cannot Hairpin
come in contact with plug. c°tter"--_
Mounting -'3
pin
LAWN MOWER
-TO ADJUST CUTTING HEIGHT
See 'q'O ADJUST CU-I-FING HEIGHT" in
the Operation section of this manual.
-<4 Mowing __<_
I 2oX. position / /
I t l
I / /
i 1 l
U4 oket f U4
LOW POSITION
HIGH POSITION
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibilitythat objects wilt
be thrown out of the rear of the mower
into the operator mowing position, if the
deflector becomes damaged, it should be
replaced.
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and all wire
tie(s) securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
6. Reassemble upper handle and all
parts removed from lower handle.
SQUEEZE
TO ADJUST
_owerhandle--"-- I
Mounting pin-----_l
Handle / _ U_I
bracket Hairpin
otte, I Jl! l
\
\
Lower
ROTATE
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is runningtoo fast or
too slow, take your mower to a qualified
service center for repairand adjustment.
CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate propedy due to
suspected carburetor problems, take your
lawn mower to a qualified service center
for repair and/or adjustment.
iMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, contact a qualified service
center, which has proper equipment and
experience to make any necessary adjust-
ments.
13