Publicidad
Idiomas disponibles
Idiomas disponibles
5
Screw all legs into the threaded inserts. HAND TIGHTEN.
FOOT
HEAD
TWIN, FULL, & QUEEN SIZES (6 LEGS)
If unassembled, plug remote control cord and power supply cord
6
into the two base motor cables. Pivot cable latch downward and
snap cable latch in closed position.
10
Plug power cord into power outlet.
NOTE
AN ELECTRICAL SURGE
PROTECTION DEVICE IS
RECOMMENDED (NOT INCLUDED).
CUSTOMER SERVICE toll free: (844) 628-8376
HEAD
NOTE
ALIGN PINS BEFORE
INSERTING PLUGS.
!
WARNING
POWER CORDS MUST
NOT INTERFERE WITH
ANY ADJUSTABLE BASE
MECHANISMS. DO NOT
WEAVE CORDS THROUGH
BASE STRUCTURE.
11
Operate remote control to test
base functions. See Remote
Control User Guide for
programming instructions.
12
Lower base to flat position.
FOOT
KING (9 LEGS)
7
Extend power cord out head end of base.
FOOT
8
Flip base onto legs.
TEAM LIFT
13
Insert the mattress retainer into the holes at the foot end of
the base. Insert the side mattress retainers into the holes on
the sides of the foot end of the base.
NOTE
Inner holes on head end of base
are to be used for headboard
bracket installation.
9
Cut the zip-tie.
HEAD
291-0101-B EDR 16952 2/23
© 2023 Leggett & Platt, Inc. Adjustable Bed Group
Publicidad
