BMS 036 Basic Manual De Usuario página 6

GETTING STARTED
The objectives have already been placed in the microscope. They are parfocal and
parcentered. Unless necessary, do not remove the objectives. Remove the microscope
carefully from the package. Open the battery holder on the bottom of the microscope.
Place the batteries in the microscope. Starting with the -side and then the +side. Close
the battery holder. The microscope is now ready for use.
POWER OPTIONS
1. Main power adapter.
2. Rechargeable batteries (AA, 1,5V), only applicable for rechargeable microscopes. It
can be ordered as a pack of three (item no. 29554). When this battery pack is placed,
it will be charged automatically when the microscope is connected to the mains and the
power switch of the microscope is switched on. When the LED indicator, located on the
back of the microscope, is green, the battery pack is fully charged. The microscope can
now be used, disconnected from the mains, for 10 hours. When the LED indicator is red,
the batteries need to be charged again. Charging time is about 3 hours.
3. Non rechargeable batteries (AA 1,5V, 3 pieces). The microscope will also work with
these batteries. WARNING: do not connect the microscope to the main electricity when
these batteries are placed. This will cause severe damage to the microscope.
SAFETY INFORMATION
• Always disconnect mains plug from power point before maintenance.
• Work in a clean and proper environment.
• Think of the safety of yourself and those working around you.
• Clean all parts coming in contact with the observed specimen to prevent infection.
• Place the microscope on a sturdy, level table or working surface.
• Always use original accessories.
CAUTION
The delicate components may get damaged if the microscope is not handled with care.
Use the microscope in a clean environment. Do not use it when it is subject to direct
sunlight, high temperatures, humidity or dust. Carry the microscope with care, do not
hold it by the stage. Remove specimen before transport.
CARE & MAINTENANCE
• Please use our special microscope maintenance kit (item no. 76026).
• Always keep the optical parts clean. Please use the dust cover to protect it.
• Avoid contamination of the objectives.
• In case there is dirt on the lens surface, use distilled water to moist and soft cloth to
clean the lens surface. Be very careful and make sure to avoid scratches on a lens
surface. Cleaning can also be done by using an alcohol solution or an optical cleaning
solution. Ventilate the room. Do not soak the lens in (cleaning) liquid.
• To clean the eyepiece- and objective-lens surface, move the cloth in a spiral motion
from the center to the rim.
• Never make a zig-zag movement since this will only spread the dirt.
• To clean painted parts, use also a slightly moistened soft cloth.
• Never use an organic solvent. Use a mild detergent, like soft hand soap.
• Do not remove the objectives from the nosepiece. The objectives were placed in a
particular sequence and are adjusted in order to have a parcentered optical system.
• Never dismantle the microscope. This can only be done by factory and/or dealer
authorized staff.
SPECIFICATIONS
For more specifications, please view the product page on the website:
www.bmsmicroscopes.com
It is within our company policy to develop continuously. BMS Microscopes b.v.
reserves the right to change design and specifications without further notice.
BMS Microscopes b.v.
Essebaan 50
2908 LK Capelle aan den IJssel
The Netherlands
Tel.: +31(0)10 458 42 22
E-mail: sales@bmsmicroscopes.com
Environment protection first!
Your appliance contains valuable materials which can be recovered
or recycled. Leave it at a local civic waste collection point.