Publicidad
Idiomas disponibles
Idiomas disponibles
Slipping,
The feeder
tripping or fall
cable and
of persons
appliance itself
can become a
cause of
tripping.
Maintenance and treatment
1. Attention – threat to life by electric shock! Disconnect
the appliance before each cleaning and treatment.
Attention – risk of appliance damage! Never clean the
appliance under running water or rinse water. Do not use
aggressive cleaning means or hard items for cleaning as
they could damage the appliance. Occasionally wipe the
appliance with a moist cloth.
2. Regularly check the steel cable (m) in its entire length for
any damage and whether the limit switch (e) is not faulty
(lift the reel up until the tension weight (l) activates the
tension clamp (c)).
3. If the steel cable (m) is damaged (broken or tattered, see
pic. 3) then replace it with an original spare cable. When
installing the cable, you must not in any case forget the
tension weight (l) so that safe tension in the end position
was ensured.
4. Regularly grease the haul-back block bearing (n) with little
oil.
5. When the appliance is switched off check the mobility of
all mechanical construction parts of the reel.
6. A specialist must check the appliance at least once a
year. The test result needs to be recorded in the Check
Book.
7. Clean the steel cable and grease it with oil once a month.
Service
Any technical questions? Complaint? Do you need spare
parts or operation manual?
Go to our website www.guede.com and the section Service
will help you quickly and without bureaucracy. Please, help us
to help you. In order to identify your device in case of
complaint, please indicate serial number, order number and
year of manufacture. All information is available on the
product label. To have all information always at hand, put
them down.
Serial number:
Order number:
Year of manufacture:
Phone:
+49 (0) 79 04 / 700-360
Fax:
+49 (0) 79 04 / 700-51999
E-Mail:
support@ts.guede.com
Important information for the customer
Please be sure to know that returning the product in or after
the warranty period must be made in the original packaging.
Depending on the installation
type, take appropriate
countermeasures suitable
installation place, installation
place marking, etc.)
16
Publicidad
