Publicidad
Idiomas disponibles
Idiomas disponibles
radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's au-
thority to operate the equipment.
•
This device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) this de-
vice may not cause harmful interference, and (2) this device
must accept any interference received, including interfer-
ence that may cause undesired operation.
• This Class B digital apparatus complies with Canadian ICES-
003.
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
IF ... IS DISPLAYED,
"Low Temperature"
(frost prevention)
..WHAT SHOULD I DO?
The appliance is fitted with a frost protec-
tion device to avoid excessive formation of
ice. The appliance starts up again auto-
matically when the defrosting process is
completed.
TURNING THE APPLIANCE ON
•
•
•
NOTE: Never switch the appliance off by removing the plug.
MODE SELECTION
The controls on the remote control are the same as those on the
control panel of the appliance (C). You should therefore refer to
the instructions in the chapter "OPERATING FROM THE CON-
TROL PANEL" to select the desired functions. Press button D7,
to switch the temperature display from °C to °F and vice versa.
IF ... IS DISPLAYED,
Probe Failure
(Probe damaged)
..WHAT SHOULD I DO?
If this is displayed, contact your local au-
thorized service center.
11
Plug into the outlet.
Press the
button (D1) (when turned on, the air con-
ditioner starts operating in the same mode as when it was
turned off) .
To switch the appliance off, press button (D1)
remove the plug.
Always switch it off by pushing on the
waiting few minutes before removing the plug. Only in this
way the appliance will perform the standard checkings.
IF ... IS DISPLAYED,
..WHAT SHOULD I DO?
Empty the internal safety tank following
the instructions in the section "End of
season operations". If HL alarm reoccurs
frequentely in Air Conditioning, Dehumi-
difying or Real Feel mode, contact your
local authorized service center.
, then
button and
"High Level"
(Internal tray full)
Publicidad
