GE PFD95 Manual De Instrucciones página 33

REVERSING THE DOOR SWING (Optional)
REMOVE, ROTATE AND REPLACE
3
THE HANDLE AND HINGE INTO
THE OPPOSITE SIDES
• Lift the handle and the hinge out of the door pockets.
NOTE: Make sure the latch remains seated inside the
handle. If it moves or falls out, seat it back into place.
• Rotate the handle and hinge, and replace them
back into the pockets on the opposite sides.
49-3000386 Rev 0
Installation Instructions
REPLACE THE INNER DOOR
4
• Replace the inner door frame into the outer door.
• Replace the 14 screws into the inner door, using a
Phillips-head screwdriver, securing it to the outer door.
NOTE: Make sure the gasket is properly seated on
the inner door frame when replaced.
REPLACE THE STRIKE PLATE
5
AND DOOR ASSEMBLY
• On the opposite side from where removed, replace
the strike plate with its two screws using a T-25 torx
driver.
• Lift the door assembly into place and secure it onto
the dryer face with its two screws using a 1/4" (6.4 mm)
nut driver.
• Close the dryer door.
NOTE: Make sure the door opens and closes
correctly. If not, repeat all steps making sure the
gasket, all parts, and screws are securely seated.
Hold the Door and
Replace Hinge Screws
into the Dryer
Replace Strike
Plate and Screws
33