Publicidad
Idiomas disponibles
Idiomas disponibles
GRASS
CATCHER
• The grass catcher may be hosed with
water, but must be dry when used.
• Check your grass catcher often for
damage
or deterioration.
Through
normal use it will wear.
If catcher needs
replacing, replace only with a manufac-
turer approved
replacement
catcher.
Give the lawn mower model
number
when
ordering.
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classification SF-SJ.
Select the oil's SAE viscosity grade
according to your expected operating
temperature.
SAE VISCOSITY
GRADES
420
0
-30
=20
.10
0
tO
20
30
40
TEMPERATURE
RANGE ANTICIPATED
BEFORE NEXT OIL CHANGE
NOTE:
Although
multi-viscosity
oils
(5W30,
10W30 etc.) improve starting
in
cold weather, these multi-viscosity oils will
result in increased oil consumption
when
used above 32°F.
Check your engine oil
level more frequently to avoid possible
engine damage from running low on oil.
Change the oil after every 25 hours of
operation orat least once a year if the
lawn mower is not used for 25 hours in
one year.
Check
the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil level.
TO CHANGE
ENGINE OIL
NOTE:
Before tipping lawn mower to
drain oil, drain fuel tank by running
engine until fuel tank is empty.
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2.
Remove engine oil cap; lay aside on a
clean surface.
3.
Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to
remove any oil trapped inside of
engine.
4. Wipe oft any spilled oil from lawn
mower or side of engine.
5.
Fill engine with oil. (See "ADD OIL" in
the Operation section of this manual).
6.
Reconnect spark plug wire to spark
plug.
13
Oil filler
AIR FILTER
Your engine will not run properly and may
be damaged
by using a dirty air filter.
Replace the air filter every 100 hours of
operation or every season,
whichever
occurs first. Service air cleaner more
often under dusty conditions.
TO CLEAN AIR FILTER
1. Remove
cover.
2.
Carefully
remove cartridge.
3.
Clean by gently tapping on a flat
surface.
If very dirty, replace cartridge.
_LCAUTION:
Petroleum
solvents,
such
as kerosene,
are not to be used to clean
cartridge.
They may cause deterioration
of
the cartridge.
Do not oil cartridge.
Do not
use pressurized
air to clean or dry
cartridge.
4.
Install cartridge,
then replace cover.
Filter
Filter
Cover
Tabs
Tabs
MUFFLER
Inspect and replace corroded muffler as it
could create a fire hazard and/or dam-
age.
SPARK
PLUG
Replace
spark plugs at the beginning of
each mowing season or after every 100
hours of operation, whichever occurs first.
Spark plug type and gap setting are
shown in "PRODUCT
SPECIFICATIONS"
in Maintenance
section of this manual.
Publicidad
