Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Attaching
an alternative
anti-tip
device
If possible,
always screw the wooden
beam to
existing studs on the rear panel of the cavity.
If the anti tip brackets cannot be attached
securely,
an alternative
anti tip device can be attached.
However, ensure that there is no play between the
appliance
and the anti tip device.
[3
Saw the wooden
beam (cross section min. 3" x 4"
(75 mm x 100 mm)) to the required length.
Length is equal to the width of the installation
cavity!
_i]
Note
If the installation
cavity is deeper than the appliance,
select a beam which has a larger cross section or
attach 2 beams.
The beam must cover the appliance
by at least 2"
(50.8 mm).
(2126,1)
• 1/32
elmm
C3
Locate watt studs near the rear panel of the cavity
and mark drill holes in the beam.
[3
Predrittthe
wooden
beam.
C3 Attach the wooden
beam to the rear panel of the
cavity.
6.
Preparing
to connect
the water
(only for appliances
which require a water connection)
Turn off the main water tap to prevent damage
caused by leaking water.
C3
C3
Attach the connecting
pipe to the shut off valve
according
to the instructions
supplied
by the
manufacturer
of the ice maker installation
kit.
Install the connecting
pipe. Always observe the
indicated
gap dimensions
to prevent damage to the
connecting
pipe when pushing in the appliance.
C3 Attach the connecting
pipe to the floor with
adhesive tape.
[3
Mark the installation
height (lower edge of the beam)
on the rear panel of the cavity.
C3 Select screws according
to the thickness
of the
wooden
beam: length - min. 2.5 x beam thickness,
diameter #12 or #14.
[_
Specify the number
of screws according
to the
cavity width, thereby ensuring that the beam can
be attached
securely.
15
Publicidad
