Fellowes Powershred LX Serie Manual Del Usuario página 3

LX20M/LX21M
A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, credit cards, staples and paper clips
Will not shred: Adhesive labels, continuous form paper,
transparencies, newspaper, cardboard, CD/DVDs, laminates,
file folders, X-rays or plastic other than noted above
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 4.0Amps (LX20M), 4.8Amps (LX21M), 5.8Amps (LX22M); heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: *1000 sheets per day, 25 credit cards. Fellowes SafeSense
shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees
Celsius) and 40 – 80% relative humidity.
WARNING IMPORTANT SAFETY INSTRUCTIONS – Read before using!
15
15
15
BASIC SHREDDING OPERATION
LX20M
Continuous operation. Up to 10-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 10-minutes will trigger
15-minute cool down period.
LX21M
Continuous operation. Up to 20-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 20-minutes will trigger
15-minute cool down period.
LX22M
Continuous operation. Up to 30-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 30-minutes will trigger
15-minute cool down period.
2
F.
A.
B.
G.
C.
D.
E.
• Operation, maintenance, and service requirements
are covered in the instruction manual. Read
the entire instruction manual before operating
shredders.
• Keep away from children and pets. Keep hands
away from paper entry.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc. – away from shredder openings. If object enters
top opening, switch to Reverse (
object.
• DO NOT use aerosol products, petroleum based or
aerosol lubricants on or near shredder. DO NOT USE
"CANNED AIR" OR "AIR DUSTERS" ON SHREDDER.
Vapors from propellants and petroleum based
lubricants may combust causing serious injury.
• Sharp edges, DO NOT touch exposed cutting blades
under shredder head.
• Do not use if damaged or defective. Do not
disassemble shredder. Do not place near or over
heat source or water.
LX22M
F.
G.
Paper shred size: Micro-Cut, 5/32 in x 1/2 in (4mm x 12mm)
Maximum Sheets per pass:
LX20M - 12*, LX21M - 16*, LX22M - 20*
Maximum Paper entry width: 9 in. (230mm)
) to back out
A. SafeSense Technology
®
B. Paper entry
C. See safety instructions
D. Pullout bin
E. Casters
F. Disconnect power switch
1. OFF
2. ON
G. Control Panel and LEDs
• This shredder has a Disconnect Power Switch
(F) that must be in the ON ( ) position to
operate shredder. In case of emergency, move
switch to OFF (O) position. This action will
stop shredder immediately. Always turn off or
unplug when not in use for an extended period
of time.
• Shredder must be plugged into a properly
grounded wall outlet or socket of the voltage
and amperage designated on the label. The
grounded outlet or socket must be installed
near the equipment and easily accessible.
Energy converters, transformers, or extension
cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards
with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
PAPER OR CARD
1
Plug in and put disconnect power
switch in ON (I) position
2
Align paper/card to center of paper
entry. Feed straight into paper entry
and release.
ENGLISH
®