MANUALE SOLLEVA MALATI
A A T T T T E E N N T T I I O O N N
The electric lifter is provided with a safety device that stops the descent if there is any
obstacle. We recommend you to let the patient go up again before removing the obsta-
cle so as to avoid any fall.
R R e e c c h h a a r r g g e e o o f f t t h h e e b b a a t t t t e e r r y y . . ( ( O O n n l l y y e e l l e e c c t t r r i i c c l l i i f f t t e e r r s s . . ) )
The batteries of the lifters of the M M O O P P E E D D I I A A line can be recharged through the battery
charger supplied with, whether the batteries are inserted in the lifter by using the
connection that is under the control box, or by disconnecting the battery and using the
present connector. While recharging the light "charge" is on. When the loading is ended,
the light "charge" will automatically turn off.
A A T T T T E E N N T T I I O O N N
During a normal functioning, when the battery power is 50% low, the control system
will give "beep" warning. At this point the battery has to be immediately re-charged
after having finished the transfer in progress.
W W a a r r n n i i n n g g s s : :
• The lifter is a device that allows short transfers of a patient with
difficulties in movement, as for example from a bed to a wheelchair or to a
commode or vice versa. The lifter must not be used to transport the patient.
• During the lifting of the patient, make sure that the base legs are in the
most widely opened position and that the brakes of the rear casters are
engaged.
• During the transfer do avoid to go against obstacles or the lifter
might tilt over.
• Always check that the slings are in a good state.
Don't use slings that are damaged or worn out.
To clean slings use a solution of alcohol and neutral soap in equal parts mixed with
water.
It is extremely important that the lifter is checked after every use:
• Particularly we recommend you to check that all screws and bolts are well tight.
• That the lifter can move freely with caster brakes off.
• Check the brakes of the rear casters for a proper operation
• Check that the "U"- shaped bracket at the end of the boom and the S-shaped hook
on the hanging bar are secured tightly
The mechanical parts have to be wet with a drop of oil for a better lubrication, particu-
larly take care of the following areas:
31-01-2006
15:05
C C L L E E A A N N I I N N G G
M M A A I I N N T T E E N N A A N N C C E E
Pagina 17
17