Publicidad
Idiomas disponibles
Idiomas disponibles
Audio controls
4
3. LEVEL: Allows you to adjust the signal level that will be sent to the speakers. Use this
control to equalize the music volume played through the speakers.
4. CROSSOVER CONTROLS: The amplifier has two selection switches with frequency
cut-off function. Each switch acts on two channels at the same time (CH1 and CH2 / CH3
and CH4).
5. BASS BOOST (LPF FREQ.): Channels CH3 and CH4 have a fixed gain of +14db at the
output when the CROSSOVER switch is in the LPF position. It is possible to change the frequency
at which the gain operates between 35Hz and 75Hz using the LPF FREQ potentiometer.
5
3
HPF: Activates the HIGH PASS filter, cutting
frequencies below 90Hz.
FLAT: It does not apply any filters, allowing all
the frequencies supported by the amplifier to be
reproduced.
LPF: Activates the LOW PASS filter, cutting
frequencies above 90Hz.
13
3
4
Publicidad
