Publicidad
Idiomas disponibles
Idiomas disponibles
EN
User Manual
PACKAGE CONTENTS
• 1 × Brill LED Lamp Mirror
• 1 × USB Charging Cable
• 1 × Quick Guide
PRODUCT DESCRIPTION: SEE PAGE 2
1. Mirror
2. LED ring
3. Function button
4. Charging indicator
5. USB-C 5 V input
6. USB charging cable
CLEANING AND MAINTENANCE
• Switch the product off and remove all plugs before cleaning.
• Do not use aggressive or abrasive cleaning agents or materials such as scouring milk or
steel wool to clean the components. They may damage the surface of the appliance!
• Protect the device from water drops and water spray. Only use a clean, dry cloth to clean
it, and never any corrosive liquids. Use a slightly damp cloth and a mild cleaning agent to
remove any stubborn dirt.
• Make sure no moisture enters the device while cleaning to prevent damage to the product
and related repairs.
STORAGE
• When no longer using the device, store it in a dry environment, away from dust and direct
sunlight.
• This product is intended for frequent use. If the device is not going to be used for a longer
period of time, make sure to recharge it every two months, at least 2 hours each time, in
order to help maintain battery performance.
• Store your device inside the original packaging.
INSTRUCTIONS
Charging
Connect the mirror to a DC5V power source using the included USB charging cable, and
it will start charging. While charging, the charging indicator will light up in red. When fully
charged, the light will change from red to green.
Mirror angle adjustment
While holding the base, tilt the mirror up and down to achieve the desired angle. It can be
adjusted up to a maximum of 90 degrees.
6
ON/OFF and color temperature
Short-press the function button to switch on the light, change the color temperature (white -
natural - warm), and switch off the light again.
Brightness
Long-press the function button to adjust the brightness. Keep the button pressed until
achieving the desired brightness, then release the button. Once set, brightness will remain
unchanged even after switching the light off and on again.
Low battery
The lamp will flash three times before switching off to indicate a low battery level. Make sure
to charge it before attempting to switch it on again.
TROUBLESHOOTING
Some issues that arise may be solved by the user. If the problem persists after having tried
the following solutions, please contact Prozis customer service.
PROBLEM
CAUSE
The battery is drained.
The device is not working.
It is switched off.
The LED ring doesn't provide
The light setting is off.
enough light.
Warranty statement
All electrical and electronic products commercialized by Prozis via www.prozis.com are cov-
ered by the warranty applicable to the purchase and sale of consumer goods.
GENERAL CONSIDERATIONS
This document contains the terms and conditions of Prozis' warranty for final consumers.
This warranty is valid exclusively for consumers who purchase the product for non-profession-
al purposes.
EN
EN
SOLUTION
Recharge the battery as
described.
Switch the lamp on by press-
ing the function button.
Use the function button to
set the desired light tem-
perature and brightness as
described.
7
7
Publicidad
