Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
BEFORE
STARTmNG THE
ENGmNE
Add
Engine
Oil
* Place generator on a [eve[surface.
° Refer to engine owner's manual and follow oil
recommendations
and instructions.
Refer to engine manual for oil fill information.
Damage to equipment
resuking from failure to follow this
instruction
will void warrant><
NOTE:
Ched<
oil often
during
engine
break-in.
Refer
to
engine
owner's
manual
for recommendations.
NOTE:The
generator
assembly
rotates
on a prehbricated
and
sealed
ball bearing
that
requires
no additional
lubrication
for the
life of the
bearing.
Add
Fuel
NOTE:
This
gasoline
engine
is certified
to operate
on
gasoline.
Exhaust
Emission
Control
System:
EH (Engine
Hodifications).
WHEN
ADDING
FUEL
Turn generator"
OFF and let it cool at least 2 minutes
before
removing
rue! cap. Loosen
cap slow, ly to relieve
pressure
in
tank.
Fill fuel tank outdoors.
DO NOT
overfill tank.Allow
space for fuel expansion.
Keep fuel away from sparks, open flames, pilot lights, heat, and
other" ignition sources.
DO NOT light a cigarette or smoke.
Use clean, fresh, regular
UNLEADED
fuel with
a
minimum
of 85 octane.
DO
NOT
use fuel which
contains
Hethanol.
DO
NOT
mix oil with
fuel.
2.
Clean
area around
fuel fill cap, remove
cap.
3.
Slowly add regular
unleaded
fuel to fuel tank. Be careful
not to overfill.Allow
about
1.5" of tank space for fuel
expansion
(Figure
3).
_NNNNNNNNNNNNNNN
_NNNNNNNNNNNNNNf"
INNNNNNNNNNNNNNN
4.
Install fuel cap and wipe up any spilled fuel.
Publicidad
