Adjusting The Channel - Monacor PA Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19

5.1 Adjusting the channel

As some frequencies may already be used by
other wireless transmission systems at the
place of operation, it is recommended to
leave the transmitter switched off while the
channel of the receiver is adjusted in order to
make sure that the transmission channel
selected is free and no interference will occur.
1) Press the button SET (8) until the channel
indication on the display (7) starts flashing.
2) While the channel indication keeps flash ing
(for approx. 10 seconds), the arrow buttons
(6) allow to select the channel: button
upward selection of the channel; button
for downward selection of the channel.
3) Confirm the channel selection with the
button SET (8). If the selection is not con -
firmed within 10 seconds, the receiver will
switch back to the previous channel.
If the LED (2) shows green after the
channel adjustment when the transmitter
is switched off, interference signals or sig-
nals from transmitters of other wireless
systems are received. In this case, set the
receiver to a different channel.
4) When an interference-free channel has
been selected for the receiver, switch on
the transmitter and set it to the same chan-
nel (→ operating instructions of the trans-
mitter).
Note: In case of transmitter ATS-16T, the
channels are marked 0 to F:
Channel 0 corresponds to channel CH 1,
Channel 1 corresponds to channel CH 2,
...
Channel F corresponds to channel CH 16.
During operation it is possible to shortly in -
dicate the radio frequency for the channel
adjusted: As long as the button
kept pressed, the display will indicate the fre-
quency instead of the channel.
All rights reserved by MONACOR
manual may be reproduced in any form or by any means for any commercial use.
6 Specifications
Radio frequency range: 863.1 – 864.9 MHz, divided
Accessory: . . . . . . . . . 1 mono earphone,
Connections: . . . . . . . . 1 mono earphone output
Power supply: . . . . . . . 2 × 1.5 V battery of size AA or
for
Dimensions: . . . . . . . . 64 × 175 × 37 mm
Weight: . . . . . . . . . . . . 182 g [with (rechargeable)
6.1 Frequencies of the channels
CH
1
2
3
4
5
6
7
8
or
(6) is
Subject to technical modification.
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction
into 16 channels (→ table
below)
dynamic 32 Ω system with
1.2 m cable
via 3.5 mm stereo jack,
1 mono line output via
3.5 mm stereo jack
2 × 1.2 V rechargeable bat te ry
of size AA
(with antenna and belt clip)
batteries]
CH 1 – CH 16
Frequency
CH
863.1 MHz
864.1 MHz
863.6 MHz
864.6 MHz
863.3 MHz
864.3 MHz
863.8 MHz
864.8 MHz
Frequency
9
863.2 MHz
10
864.2 MHz
11
863.7 MHz
12
864.7 MHz
13
863.4 MHz
14
864.4 MHz
15
863.9 MHz
16
864.9 MHz
GB
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Txa-800r

Tabla de contenido