Profi Care PC-BS 3110 Manual De Instrucciones página 34

Filter Insert
CAUTION:
• Never wash the filter in the washing machine.
• Do not use a hairdryer for drying.
• Only use the appliance after the filters have been
installed correctly.
Proceed as follows to remove, clean and reinstall the filter
insert:
1. Empty the dust collector as described previously.
2. Remove the dust collector lid. Turn it anticlockwise in the
direction of .
NOTE:
The markings " " and "
side of the dust container.
3. Remove the fine dust filter. Remove the foam insert from
the fine dust filter.
4. Remove the coarse dirt filter from the dust collector. To
do this, reach into the recesses of the filter and remove
it by pulling it upwards.
5. Use a brush to clean the filters. In case of heavy stain-
ing, clean the filters under running water.
6. Let the filters air-dry completely before refitting them!
7. Wipe the dust collector with a damp cloth and then wipe
it dry.
NOTE:
If moisture gets into the rubber seal of the base plate,
carefully remove the seal and dry it as well as the
base plate. Replace the seal.
WARNING:
• Pull the mains plug out of the socket before cleaning or main-
taining the appliance.
• Under no circumstances should you immerse the appliance in
water for cleaning purposes. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Clean the housing with a soft, dry cloth without additives.
34
PC-BS3110_IM
" are imprinted on the right
Cleaning
8. Put the coarse dirt filter back into the collector. Make
sure that the guides are seated in the openings.
NOTE:
The recesses are made in such a way that the
guides fit in one position only. This prevents incorrect
assembly.
9. Insert the foam insert into the fine dust filter. The smooth
side must be visible.
Place the fine dust filter onto the coarse dirt filter.
10. Put the lid back on the dust collector. The guides must
fit into the openings. Press it gently and turn it clockwise
until it clicks into position.
NOTE:
The recesses are made in such a way that the
guides fit in one position only. This prevents incorrect
assembly.
Check the correct fit of the cover. The flattened side of
the handle must fit over the hose connector.
11. Fit the dust collector in the appliance.
Outlet Filter
The appliance is also equipped with an outlet filter.
It is located on the back of the unit next to the parking aid.
1. Push down the lever (10) and remove the ventilation
grille.
2. Remove the filter insert and clean it. You can brush out
the filter.
3. Reinsert the filter. The guide eyes have to point up-
wards.
4. Put the ventilation grille back on the appliance. Observe
the guide lugs. The ventilation grid must engage audibly.
Storage
• Let the appliance cool down completely.
• Wind the cable completely.
• Please insert the hook of the floor nozzle into the parking
assistant on the rear of the appliance.
06.10.22