CMP HT0063 Instrucciones De Uso página 25

Ecodesign requirements for external power supplies
Information Value and
published precision
Manufacturer's name or trade
mark, commercial
number and address
Model identifier
Input voltage 100-240
Input AC 50/60
frequency
Output 5.0/9.0/12.0
voltage
Output 3.0 / 2.0 /
current 2.22 / 1.5 /
1.67
Output 15.0 / 18.0 /
power 20
Average 88.82
active
efficiency
Efficiency at 62.43
low load (10
%)
No-load 0.00
power
consumption
Unit Notes
Groupe CMP
registration ZI Le Carré des Aviateurs – Bât 4C/4D - 157, avenue Charles
Floquet, 93150 Le Blanc-Mesnil – France
HT0063
V~ Specified by the manufacturer. Shall be a value or a range.
⎓
Hz Specified by the manufacturer. Shall be a value or a range.
Nameplate output voltage. Shall indicate whether is AC or DC.
V
In cases where more than one physical output or more than one
output voltage at load condition 1 are measured, the sets of
available Output voltage — Output current – Output power shall
be published.
A Nameplate output current.
In cases where more than one physical output or more than one
output voltage at load condition 1 are measured, the sets of
available Output voltage — Output current – Output power shall
be published.
W Nameplate output power.
In cases where more than one physical output or more than one
output voltage at load condition 1 are measured, the sets of
available Output voltage — Output current – Output power shall
be published.
% Declared by the manufacturer based on the value calculated as
arithmetical mean of efficiency at load conditions 1-4.
In cases where multiple average active efficiencies are declared
for multiple output voltages available at load condition 1, the value
published shall be the average active efficiency declared for the
lowest output voltage.
% Declared by the manufacturer based on the value calculated at
load condition 5.
External power supplies with a nameplate output power of 10 W
or less shall be exempted from this requirement.
In cases where multiple average active efficiencies are declared
for multiple output voltages available at load condition 1, the value
published shall be the value declared for the lowest output voltage.
W Declared by the manufacturer based on the value measured for
load condition 6.
Edited and imported by Groupe CMP
ZI Le Carré des Aviateurs – Bât 4C/4D - 157, avenue Charles Floquet
93150 Le Blanc-Mesnil – France
www.cmp-paris.com
Made in China