Nolan N120-1 Seguridad E Instrucciones página 18

N120-1
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjust-
ment external levers are turned inwards (Fig.9).
1.3 Place the PINLOCK
The silicone profile of the PINLOCK
inner surface of the visor.
1.4 Insert one side of the PINLOCK
it in position (Fig.10).
1.5 Widen the visor and fasten the other side of the PINLOCK
pin (Fig.11).
1.6 Release the visor.
1.7 Remove the protective film from the PINLOCK
entire silicone profile of the inner visor adheres to the visor.
1.8 Assemble the visor on the helmet (see instructions above).
2 CHECKING AND ADJUSTING THE STRETCH
Check the correct PINLOCK
and ensuring that they do not move with respect to each other.
Should the PINLOCK
gradually and not excessively, both external adjustment levers turning them upwards,
to increase the stretch (Fig.9). The maximum stretch is achieved when the pin adjust-
ment external levers are placed outwards.
WARNING
- Dust between the two visors may cause both surfaces to scratch.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, use in particular weather conditions (low tempera-
tures, high humidity, sudden changes in temperature or heavy rain) or intense and
prolonged use may affect the performance of the PINLOCK
fogging or formation of condensation. In such cases, to restore the system effi-
ciency after using the helmet, remove the PINLOCK
visor and leave it to dry in warm and dry air. The same procedure must be applied
to the helmet, which should be left to dry to remove any humidity that may have
formed as a result of the conditions described above.
3 DISASSEMBLING THE PINLOCK
3.1 DISASSEMBLE THE VISOR EQUIPPED WITH THE PINLOCK
structions above).
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
18
INSTRUCTIONS FOR USE
inner visor on the visor.
®
inner visor onto one of the two visor pins and hold
®
inner visor assembly by opening and closing the visor
®
inner visor not be tightly fixed to the visor, simultaneously move,
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
inner visor must be in contact with the
®
inner visor and check that the
®
®
inner visor may result in exces-
®
®
INNER VISOR
®
inner visor from the pins (Fig.11).
®
inner visor to the other
®
inner visor to prevent it from
inner visor and cause
®
inner visor from the helmet
inner visor (see in-
®