Descargar Imprimir esta página

Metra GM11-SWC/GM1 Instrucciones De Instalación

Interfaz de datos con swc 200-2013

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

GM Data Interface with SWC 2000-2013*
* For non-amplified models, or models with an analog activated amplifier
INTERFACE FEATURES
• Retains R.A.P. (retained accessory power)
• Provides wires for multimedia radios
(parking brake, reverse, speed sense)
• Retains chimes
• Retains audio controls on the steering wheel
• Retains balance and fade
From time to time vehicle and aftermarket radio
manufacturers make changes to their products. Go
to http://www.metraupdater.com to download the
Metra Updater program to update your interface
using the supplied updated cable.
*Note: The updater program is windows based only.
Having difficulties? We're here to help.
Contact our Tech Support line at:
386-257-1187
Or via email at:
techsupport@metra-autosound.com
Tech Support Hours (Eastern Standard Time)
Monday - Friday: 9:00 AM - 7:00 PM
Saturday: 10:00 AM - 7:00 PM
Sunday: 10:00 AM - 4:00 PM
APPLICATIONS
Buick
Century
2004-2005
Lacrosse
2005-2009
Rainier
2004-2007
Regal
2004
Rendezvous (2)
2002-2007
Terraza (2)
2005-2007
Cadillac
Escalade (1)
2003-2006
Escalade ESV (1)
2003-2006
Escalade EXT (1)
2003-2006
Chevrolet
Avalanche
2003-2006
Cavalier
2000-2005
Colorado
2004-2012
Corvette
2005-2013
Express
2003-2007
Impala
2000-2005
Kodiak C4500-C8500
2003-2009
Malibu
2001-2003
Malibu Classic
2004-2005
Monte Carlo
2000-2005
Silverado
2003-2006
© COPYRIGHT 2021 METRA ELECTRONICS CORPORATION
Chevrolet (Cont)
Silverado Classic
SSR
2003-2006
Suburban
2003-2006
Tahoe
2003-2006
SWC*
Trailblazer
2002-2009
(hold)
Uplander
2005-2008
(hold)
(tap)
GMC
(hold)
Canyon
2004-2012
(hold)
Envoy
2002-2009
(hold)
Savana
2003-2007
GMC (Cont)
(tap)
Sierra
2003-2006
(tap)
Sierra Classic
(tap)
Top Kick C4500-C8500
2005-2009
Yukon
2003-2006
SWC*
Yukon XL
2003-2006
(tap)
(tap)
Hummer
(tap)
H2 (1)
2003-2007
(hold)
H3
2006-2010
(tap)
H3T
2006-2010
(hold)
* SWC Programming Sequence
(tap)
(hold) Press and hold the Volume Up button to program the interface.
(tap)
Tap the Volume Up button to program the interface.
(tap)
(tap)
(1) These vehicles are standard for an amp and must be bypassed.
(hold)
(2) DO NOT cut pin 5 for these vehicles
(tap)
GM11-SWC/GM1
I N S TA L L AT I O N I N S T R U C T I O N S
SWC*
Isuzu
2007
(tap)
Ascender
(tap)
H Series
(tap)
I Series pickups
(tap)
(tap)
Oldsmobile
(hold)
Alero
Bravada
Intrigue
(tap)
Pontiac
(tap)
(tap)
Aztec
Grand Am
Grand Prix
(tap)
Montana SV6
2007
(tap)
Sunfire
(tap)
(tap)
SAAB
(tap)
9-7X
Saturn
(tap)
Relay
(tap)
(tap)
SWC*
2003-2008
(tap)
2003-2008
(tap)
2006-2008
(tap)
2001-2004
(hold)
2002-2004
(tap)
2002
(hold)
2001-2005
(hold)
2001-2005
(hold)
2004-2008
(hold)
2005-2006
(hold)
2000-2005
(tap)
2005-2009
(tap)
2005-2007
(hold)
Product Info
REV. 10/18/21 GM11-SWC/GM1

Publicidad

loading

Resumen de contenidos para Metra GM11-SWC/GM1

  • Página 1 Sierra 2003-2006 (tap) to http://www.metraupdater.com to download the Montana SV6 2005-2006 (hold) Escalade ESV (1) 2003-2006 (tap) Sierra Classic 2007 (tap) Metra Updater program to update your interface Sunfire 2000-2005 (tap) Escalade EXT (1) 2003-2006 (tap) Top Kick C4500-C8500 2005-2009 (tap) using the supplied updated cable. Yukon 2003-2006...
  • Página 2 CONNECTIONS Interface Box Reset Button Vehicle Connectors Connect interface harness to aftermarket radio harness Black - Ground Aftermarket Radio (radio’s features may vary) Yellow - Battery power Front Red - Accessory power Rear View Rear AUX-IN Vehicles without steering wheel controls Orange - Unlabeled Purple/Black - Rear right speaker - 1. From the 3.5mm adapter, tie the Brown and Brown/White Blue/White - Amp turn-on (connect) wires together and tape up or use a connector. Blue/Pink - VSS/Speed-Sense 2. Connect the 3.5mm adapter to the 3.5mm jack from the Green/Purple - Reverse signal vehicle harness.
  • Página 3 • Volume Up • Seek Up • Volume Up • PTT (OnStar) or MUTE • Volume Up 2. Connect the LD-GM11 harness to the interface, and then to the wiring harness in the vehicle. Turn the ignition off, then back on. 3. Locate the Volume Up button on the steering wheel. Program the interface by pressing Volume Up and holding the Volume Up button until the LED stops flashing. Test all functions of the installation for proper operation. Reset Button 4. The LED will flash Green & Red while the interface programs the radio to the steering wheel controls. Once programmed, the LED will go out, then produce a pattern which will identify the radio type installed. Green & Red LED If the interface fails to function, press and release the reset button. The reset button can be found to the right of the 20 pin connector inside the green plastic Green or Red LED housing. Using a small pointed tool press the blue button for 2 seconds and release. The LED will start flashing green and red, immediately proceed to step 3. Reset Button REV. 8/17/21 GM11-SWC/GM1...
  • Página 4 PROGRAMMING (TAP) 1. 6. Open the driver’s door, and keep open during the programming process. Turn the ignition off, then back on. Turn the ignition on. 7. Test all functions of the installation for proper operation. 2. Connect the GM11 interface harness to the interface, and then to the wiring harness in the vehicle. 3. Locate the Volume Up button on the steering wheel. Program the interface Tap Volume Up by tapping the Volume Up button at a heartbeat pace until the LED stops flashing. Note: If the LED shows Solid Green for Pass (indicating everything programmed correctly), yet the steering wheel controls don’t work, make sure that the 3.5mm jack is plugged in, and plugged into the correct jack in the radio. Once corrected, press the reset button, then program again. 4. The LED will flash Green & Red while the interface programs the radio to the LED Light Radio Programming Section Vehicle Programming Section steering wheel controls. Once programmed, the LED will go out, then Solid Green Pass Pass produce a pattern which will identify the radio type installed.
  • Página 5 Visite la página http://www.metraupdater. Sierra 2003-2006 (toque) Montana SV6 2005-2006 (mantenor) Escalade ESV (1) 2003-2006 (toque) com para descargar el programa Metra Updater, que le Sierra Classic 2007 (toque) Sunfire 2000-2005 (toque) Escalade EXT (1) 2003-2006 (toque) permitirá actualizar su interfaz utilizando el cable de...
  • Página 6 CONEXIONES Caja de interfaz Botón de reinicio Vehículo Conectores Conecte los arneses de la interfaz al arnés del radio genérico Radio del mercado de accesorios Negro: Tierra (las funciones de la Amarillo: Energía de batería Front radio pueden variar) Rojo: Energía secundaria Rear View Rear AUX-IN...
  • Página 7 Con una pequeña herramienta puntiaguda, presione el botón Green or Red LED azul durante 2 segundos y suéltelo. El LED comenzará a parpadear en verde y rojo, proceda inmediatamente al paso 3. Botón de reinicio REV. 8/17/21 GM11-SWC/GM1...
  • Página 8 PROGRAMACIÓN (toque) Abra la puerta del conductor y manténgala abierta durante el Apague la ignición. Después, vuelva a encenderla. proceso de programación. Conecte el arnés LD-GM11 correcto a la interfaz y, después, al arnés de Haga pruebas en todas las funciones de la instalación para cableado en el vehículo.