AMiO YD-396C Instrucciones De Uso

EN
EN - USER MANUAL
Cordless digital car air compressor 03689 / YD-396C
PRODUCT DESCRIPTION
1. Display Screen
2. Switch
3. Air nozzle
4. Led Light
5. Charging Port
6. Nozzles Cover
7. French air nozzle conversion needle air nozzle
8. Air Hose
9. USB TYPE-C
USE
1. The product is equipped with a switch
press 2 seconds, the screen lights up and turn
on.If no operation is performed after power-on,
the screen enters hibernation made 1.5 minutes
later.
2. In hibernation made, tap
down the switch for three seconds to power it
off. The product shuts down automatically alter
10 seconds in hibernation made.
3. Tap to switch the scene, and display the set
value un der this made and blink three times.
The display sequence is car, motorcycle, bicycle
and basketball made respectively. Long press
for 2 seconds as the unit switch, the unit
display sequence is PSI, BAR, Kpa , Kg/cm2. Stop
the operation to conlirm the selected made or
unit.
4. Short press + or - to enter the pressure setting
state (display set value flash 3 times, exit tire
pressure setting state without operation for 3
seconds, short press + or - set pressure value
increase or decrease, long press + or - pressure
value increase or decrease rapidly, pressure val-
, long
to light up, and hold
ue automatic cycle and memory lunction alter
restart. Stopping the operation confirms a se-
lected pressure value.
5. Alter completing all Settings, tap
duct starts to work.
6. When the product is working, press + or - or
, the air compressor will not stop working. To-
uch to stop working immediately. Touch
continue working until the air pressure reaches
the set point.
7. Light touch , press the first time to steady on,
press the second time to slow blink, press the
third time to fast blink (SOS made), press the fo-
urth time to close. And so on.
TECHNICAL SPECIFICATIONS
• Voltage: DC 7.4V
• Air flow: 11L/min
• Max. Pressure: 150PSI / 10BAR
• Capacity: 2000mAh x2
• Using time: 25 min
• Plug: 5V 1A
DECLARATION OF CONFORMITY
DECLARATION OF CONFORMITY AVAILABLE AT
THE REGISTERED OFFICE OF AMIO SP z o.o. ul.
Handlowa 3, 41 - 807 Zabrze.
WASTE MANAGEMENT AND RECYCLING
To prevent damage during transport, the
appliance is contained in packaging. This
packaging is raw material that can be reused
or can be recycled. The appliance and its
accessories consist of different types of materials,
such as metal and plastic. Please take damaged
appliance components to a recycling collection
point. For EU countries only It is forbidden to
dispose of the appliance in the rubbish. According
to the European Directive 2012/19/EU on Waste
Electrical and Electronic
unusable power tools must be collected separately
and taken to a collection point for recyclable
materials. Recycling as an alternative to the
obligation to return the appliance: As an alternative
to the obligation to return the appliance at the end
of its useful life, the owner is obliged to participate
in its proper disposal. The end-of-life device can
also be taken to a recycling collection point, which
will carry out the disposal in accordance with
national waste and recycling regulations.
P/N: 03689 / YD-396C
and the pro-
Equipment (WEEE),
and
1