GE GUD37 Manual De Instrucciones página 17

Troubleshooting Tips - Washer
Operation
Washer won't
operate
Movement inside
machine when shut
off
Short spray and
delay after pushing
the Start button
Washer spins
and pauses at the
beginning of cycles
Washer pauses
during wash cycle
Basket seems loose Basket moves or rotates
Blinking Spin light
or Spin light on at
end of cycle
49-90582-1
Possible Causes
Washer is unplugged
Water supply is turned
off
Controls are not set
properly
Lid is open—safety
feature prevents agitation
and spinning when lid is up
Circuit breaker/fuse is
tripped/blown
Electronics need to be
reset
Start was not pressed
Shifting mechanism is
disengaging the motor
Lid was opened and
closed between cycle
selection and start
This is normal
The Soak Option was
chosen
This is normal
freely
Out of balance condition
has been detected
What to do
Make sure cord is plugged securely into a working outlet.
Turn both hot and cold faucets fully on.
Check controls.
Close lid and reset cycle, to the beginning if necessary.
Check house circuit breakers/fuses. Replace fuses or reset
breaker. Washer should have separate outlet.
Unplug washer, wait 2 minutes, plug back in and press Start.
Press Start.
When the machine is manually turned off, the shifter will
disengage the motor before completely shutting down.
If lid is raised before the motor is disengaged, it will resume
when lid is closed.
This is normal. See START-UP SEQUENCE in the Safety
Instructions section.
The washer is sensing the load.
This is normal. The washer alternates between agitate and
soak during these cycles to get your clothes cleaner with less
wear.
Many cycles incorporate as series of soaks within the agitation
period to get your clothes clean with less wear.
Washer basket does not have a traditional brake. Washer
basket will move freely. This is normal.
Allow cycle to continue and finish.
If load is wet at the end of the cycle, even out load and run a
Drain & Spin cycle.
17