Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the roller brush: (Fig. 6)
1. Remove the motorized power brush from the main unit.
2. Press the brush release button and, without releasing it, lift the flap in an upward
direction.
3. Release the button and remove the brush.
4. Carefully clean and remove the hairs and debris from the brush roller. Wipe to clean
only, do not use any soap or harsh cleaning solvents. If roller brush becomes damp,
allow to dry naturally before replacing.
5. For installation, please install in the reverse order of disassembly.
TROUBLESHOOTING
PROBLEM
Appliance is not powered
on
Vacuum is stopped sud-
denly
Suction of the vacuum is
reduced
Motorized power brush is
not rotating
POSSIBLE CAUSES
This can occur if the
appliance has been used
or stored for an extended
period of time
This will occur if the safety
cut-out device has been
activated. This device is
designed to prevent your
appliance from overheating
This is probably caused by
dust blockages
This tends to occur when
there are too many fibers
wrapped around the brush
roll, restricting the move-
ment
SOLUTION
Connect the vacuum to the char-
ger and allow for a full charging
cycle to complete
Ensure the vacuum is turned off,
disconnect all accessories and
leave to cool down for at least
half an hour before attempting
to operate again. Try to identify
the source of the overheat by
checking for blockages in the
extension tube motor-drive floor
head and accessories. Empty
the dust container and clean or
replace the filter
Turn the vacuum off. Discon-
nect the floor head, extension
tube and any accessories. Check
for and remove any blockages
from the dustbin filter, air duct,
extension tube floor head and
accessories
Check the maintenance section
of this manual for instructions on
how to appropriately clean the
brush roll
23
Publicidad
