Philips AUT1211 Manual página 8

e. Switch off the three-way ball valve. Turn on the cold water supply. Wipe the connections with a
tissue to see if there is leakage. If the tissue stays dry, it means the three-way ball valve is installed
properly.
3. Installing the faucet
Note:
Select an appropriate installation position. The environment where the faucet is installed should
adhere to any appropriate hygiene and sanitation conditions. Make sure the faucet sits �at on top of
the sink or countertop surface.
a. Drill a hole with a diameter of 25mm. Skip this step if there is already a hole in the sink or the
countertop surface.
b. Install the faucet according to the diagram. Screw the faucet rod nut to the faucet rod, and screw it
tightly.Under the sink, insert the quick connector to the faucet pipe, and use a clip to secure the
connections.
Quick connector
Hot Cold
Handle
Iron Washer
Rubber washer (Large)
Rubber washer (medium)
Counter surface
Rubber washer (small)
Nut
8